User manual HATCO FSHACM-0106(1)

[. . . ] FLAV-R-SAVOR ® Heated Air Curtain Cabinets FSHAC & FSHACH Series Installation & Operating Manual I&W #07. 05. 164. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Filter Cartridge Water Supply Inlet Figure 8. Plumbing Connections NOTE: Install filter cartridge with flow arrow towards the equipment. Insert water supply tubing fully into filter cartridge. Secure tubing to water filter cartridge with fittings. Attach minimum tubing length from filter cartridge to equipment. Connect filter cartridge assembly to equipment water supply inlet. Check for leaks before leaving installation. NOTE: Flush new filter cartridge with water for five minutes before use. INSTALLATION See MAINTENANCE section for Filter Cartridge Replacement. A drain connection is located inside the cabinet cavity for manually draining the water reservoir. (See Figure 9. ) A male hose connector is included. See MAINTENANCE for draining information. Drain Outlet Figure 9. Drain Outlet on Humidified Units OPERATION WARNING Some exterior surfaces on the unit will get hot. Use caution when touching these areas to avoid injury. WARNING To prevent any injury, discontinue use if power cord is frayed or worn. For safe and proper operation the unit must be located indoors where the ambient air temperature is a minimum of 70°F (21°C) and a maximum of 85°F (29°C). FSHAC CONTROL PANEL 1. Plug unit into an electrical outlet of the correct voltage, size and plug configuration. Turn the Power Switch on the control panel to the ON position. The Power Switch and the Digital Display will light up at this time. Set Air temperature by pushing TEMPERATURE button once to display "tsp. " Push button again to display current temperature setting. Push the UP or DOWN arrow buttons until desired temperature setting is reached. Digital display will return to current cabinet temperature in a few seconds. Figure 10. FSHACM-0106 8 OPERATION FSHACH CONTROL PANEL 1. [. . . ] Repair Service Independence 216-459-8700 E. Oklahoma City 405-235-2184 Krueger, Inc. Oklahoma City OREGON Ron's Service, Inc. Portland PENNSYLVANIA Elmer Schultz Services Philadelphia 215-627-5401 FAST Comm. [. . . ]