User manual HATCO GR2SDM-0102

[. . . ] GLO-RAY GR2SD Series Installation & ® Designer Merchandising Warmer Operating Manual I&W # 07. 05. 078. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] CAUTION The National Sanitation Foundation (NSF) requires that GR2SD Series units over 36" (91 cm) in length or weighing more than 80 lbs. (36 kg) to be either sealed or raised on the installation surface. If this unit cannot be sealed at the point of use, 4" (10 cm) legs are included to allow for proper cleaning access below unit. See Hatco ACCESSORIES for installation instructions. OPERATION The Designer Merchandising Warmer power is controlled by the ON/OFF toggle switch. The switch must be on the ON position for the unit to function. The thermostatically controlled base can be set to any desired heating level as indicated on the control plate. NOTE: Main power switch must be in the ON position for the heated base to function. CAUTION Some exterior surfaces on the unit will get hot. Use caution when touching these areas to avoid injury. OFF ON 80 F 28 C 200 F 93 C HATCO CORPORATION, Milwaukee, WI ON/OFF Toggle Switch Thermostat Control Figure 5. Controls WARNING Do not place food product directly onto hardcoat surface. Food product must be wrapped, boxed or on a food pan. Form No. GR2SDM-0102 10 MAINTENANCE GENERAL The Hatco Glo-Ray Designer Merchandising Warmers are designed for maximum durability and performance, with minimum maintenance. WARNING To avoid any injury, turn the power switch off at the fuse disconnect switch/circuit breaker or unplug the unit from the power source and allow to cool completely before performing any maintenance or cleaning. WARNING To avoid electrical shock or personal injury, do not steam clean or use excessive water on the unit. Do not operate if it has been submerged in water. WARNING To avoid electric shock, always unplug the unit before performing cleaning or maintenance. DISPLAY LIGHT BULB REPLACEMENT The display light is an incandescent light bulb which illuminates the warming area. The bulb has a special coating to guard against injury and food contamination in the event of breakage. To replace a light bulb, disconnect the power supply and wait until the unit has cooled. Unscrew the light bulb from the unit and replace it with a new specially coated incandescent bulb. NOTE: Hatco shatter-resistant light bulbs meet N. S. F. standards for food holding and display areas. For 120 volt applications, use Hatco part #02. 30. 043. 00. . [. . . ] Service Philadelphia 215-288-4800 GCS Service, Inc. Pittsburgh 412-787-1970 K & D Service Co. Harrisburg 717-236-9039 Elmer Schultz Services Philadelphia 215-627-5401 Electric Repair Co. Reading 610-376-5444 RHODE ISLAND Marshall Electric Co. [. . . ]