User manual HATCO GRBWM-0302

[. . . ] GLO-RAY ® Buffet Warmers GRBW Series Installation & Operating Manual I & W #07. 05. 012. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Turn the top toggle switch to the ON position. The infrared heat and incandescent lights are controlled by the toggle switch. This switch must be in the ON position when in use. If the unit is equipped with an optional infinite switch, this switch will control the top heat and the toggle switch will control the lights only. The infinite control allows the operator to manually adjust the upper heat output from low to high. Turn the bottom thermostat control to the desired setting. Allow unit 15-20 minutes to reach operating temperature. Thermostat Control Figure 5. Operating Controls. ON Top Controls ­ GRBW HATCO GLO-RAY FOOD WARMER MED OFF LO W HIG H HATCO CORPORATION, Milwaukee, WI On/Off Toggle Switch Infinite Switch (optional) Bottom Controls ­ GRBW 80 F 28 C 200 F 93 C Form No. GRBWM-0302 6 MAINTENANCE CLEANING Hatco Glo-Ray Buffet Warmers are designed for maximum durability and performance, with minimum maintenance. WARNING To avoid any injury, turn the power switch off at the fuse disconnect switch/circuit breaker or unplug the unit from the power source and allow to cool completely before performing any maintenance or cleaning. WARNING To avoid electric shock or personal injury, do not steam clean or use excessive water on the unit. WARNING To prevent electric shock, always unplug the unit before performing cleaning or maintenance. Do not operate if unit has been submerged in water. To preserve the finish of the Glo-Ray Buffet Warmer, it is recommended that the surfaces be wiped daily with a damp cloth. Stubborn stains may be removed with a good non-abrasive cleaner. Hard to reach areas should be cleaned with a small brush and mild soap. Abrasive cleaners could scratch the finish of your unit marring its appearance and making it susceptible to soil accumulation. Clean acrylic surfaces with a common glass cleaner and nonabrasive paper toweling or a soft cloth. CAUTION Only soft cleaning cloths should be used to clean breath protector(s). Breath protector(s) are made of shatterproof polycarbonate and will scratch if proper care is not taken. DISPLAY LIGHT BULB REPLACEMENT The display lights are shatter-resistant, incandescent light bulbs which illuminate the warming area. These bulbs have a special coating to guard against injury and food contamination in the event of breakage. To replace a light bulb, disconnect the power supply from the unit and wait until the unit has cooled. [. . . ] Portland 503-231-7171 503-624-0890 PENNSYLVANIA Authorized Factory Service Coraopolis 412-262-2330 FAST Comm. Service Philadelphia 215-288-4800 GCS Service Pittsburgh 412-787-1970 K & D Service Co. Harrisburg 717-236-9039 Elmer Schultz Services Philadelphia 215-627-5401 Electric Repair Co. Reading 610-376-5444 RHODE ISLAND Marshall Electric Co. [. . . ]