User manual HATCO GRCSM-0401

[. . . ] GLO-RAY Installation & ® CARVING STATION Operating Manual I&W #07. 05. 039. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Areas which are susceptible to active air movements or currents should be avoided, i. e. , near exhaust fans or hoods and air conditioning ducts. The unit should also be located in an area convenient for proper counter height and in accordance with traffic patterns. The Carving Station can sit on top of the Hatco Chef System Cook and Hold 5-pan Oven and the Flav-R-Savor Holding Cabinet. For safe and proper operation, place the foodwarmer a reasonable distance from combustible surfaces. CUSTOM DRIP PAN The custom drip pan fits tightly onto the base of the carving station. LOCATION CAUTION For safe and proper operation, the Carving Station must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. Form No. GRCSM-0401 4 OPERATION The Carving Station power for the top ceramic heat and the incandescent lights are controlled by the on/off toggle switch. The switch must be in the "ON" position for the unit to function. To control the top heat, set the infinite switch to the desired heating level. For models with heat in the base, power is independently controlled by the on/off rocker switch. Set base control thermostat to the desired heating level as indicated on the control plate. WARNING Some exterior surfaces on the Carving Station will get hot. Use caution when touching these areas to avoid injury. Base Control Thermostat On/Off Rocker Switch Figure 5. Controls Heat Control Infinite Switch On/Off Toggle Switch 5 Form No. To preserve the bright finish of the Carving Station, it is recommended that the surfaces be wiped daily with a damp cloth. Stubborn stains may be removed with a stainless steel cleaner or a non-abrasive cleanser. Abrasive cleaners could scratch the finish of your Glo-Ray Carving Station marring its appearance and making it susceptible to soil accumulation. Do not operate if it has been submerged in water. DISPLAY LIGHT BULB REPLACEMENT The display light is an incandescent bulb which illuminates the warming area. This bulb has a special coating to guard against injury and food contamination in the event of breakage. To replace a bulb, disconnect the power supply and wait until the unit has cooled. Unscrew the bulb from the unit and replace it with a new specially coated incandescent bulb. Hatco shatter-resistant bulbs meet N. S. F. standards for food holding and display areas. [. . . ] Oklahoma City 405-528-8883 OREGON Bressie Electric Co. Portland 503-231-7171 503-624-0890 PENNSYLVANIA Authorized Factory Service Coraopolis 412-262-2330 FAST Comm. Service Philadelphia 215-288-4800 GCS Service, Inc. Pittsburgh 412-787-1970 K & D Service Co. [. . . ]