User manual HATCO GRHWSGDM-0902

[. . . ] GLO-RAY ® Merchandising Warmer GRHW-1SGD Series Installation & Operating Manual I&W # 07. 05. 127. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] NOTE: Side glass panels have a special "Low E" coating applied to one side. The "Low E" coated side must face inward and the word on the glass "out" must face outward. CAUTION Do not lay unit on the side with the control panel or damage to unit could occur. CAUTION Do not drag or slide the unit when moving or installing. Carefully lift the unit to prevent the rubber feet from tearing off. OU T Figure 4. Side Glass Installation CAUTION Unit is not weatherproof. For safe and proper operation locate the unit indoors where the ambient air temperature is constant and is a minimum of 70°F (21°C). LOCATION For proper operation and maximum performance, locate the Merchandising Warmer in an area where the ambient air temperature is constant and is a minimum of 70°F (21°C). Areas which are susceptible to active air movements or currents should be avoided, i. e. , near exhaust fans or hoods and air conditioning ducts. WARNING For safe and proper operation, the unit must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. Form No. GRHWSGDM-0902 4 OPERATION CAUTION Locate the unit at the proper counter height, in an area that is convenient for use. The location should be level to prevent the unit or its contents from accidentally falling, and strong enough to support the weight of the unit and food displayed. CAUTION Some exterior surfaces on the unit will get hot. Use caution when touching these areas to avoid injury. Plug unit into a properly grounded electrical outlet of the correct voltage, size and plug configuration. Place the On/Off rocker switch in the ON position. The incandescent lights and upper infrared heat are controlled by the rocker switch. The rocker switch must be in the ON position when in use. The stainless steel base heat is regulated by a preset electronic temperature controller set for 200° F. If an adjustment is required remove the protective cover and follow these steps: A. To set temperature, turn Mode Switch counterclockwise to the "SP-1" position. Using a small screwdriver turn the setpoint screw until the desired temperature setting is indicated. [. . . ] Pompano Beach 954-971-0456 650-635-1900 Electrical Appl. Repair Service Independence 216-459-8700 E. Oklahoma City 405-235-2184 Krueger, Inc. Oklahoma City OREGON Bressie Electric Co. [. . . ]