User manual HATCO GRMWM-0505(1)

[. . . ] GLO-RAY® Multi-Staging Warmer GRMW Series Installation & Operating Manual I&W #07. 05. 157. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] To prevent delay in obtaining warranty coverage, fill out and mail in the warranty card. Remove tape and protective packaging from all surfaces of unit. The GRMW-3 and GRMW-4 series units are supplied with pan dividers. To install them, place the dividers in the channels provided. Installing Pan Dividers WARNING For safe and proper operation, the unit must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. CAUTION To avoid any injury or damage locate the unit at the proper counter height, in an area that is convenient for use. The location should be level to prevent the unit or its contents from accidentally falling, and strong enough to support the weight of the unit and food. LOCATION NOTE: Unit must be transported in the upright position. For proper operation and maximum performance, locate the Multi-Staging Warmer in an area where the ambient air temperature is constant and is a minimum of 70°F (21°C). Areas which are susceptible to active air movements or currents should be avoided, i. e. , near exhaust fans, hoods and air conditioning ducts. For safe and proper operation the unit must be located indoors where the ambient air temperature is a minimum of 70°F (21°C) and a maximum of 85°F (29°C). Form No. Plug unit into a properly grounded electrical outlet of the correct voltage, size and plug configuration (see SPECIFICATIONS for details). To begin operation, place the ON/OFF toggle switch in the ON position. Allow 20-30 minutes for the unit to reach operating temperatures. WARNING To avoid any injury or damage to the unit do not pull unit by power cord. Front Door "Middle" Screw/Slide Adjustment Screw CAUTION - HOT WARNING To prevent any injury, discontinue use if power cord is frayed or worn. WARNING Some exterior surfaces on the unit will get hot. Use caution when touching these areas to avoid injury. NOTE: The unit comes equipped with a thermostat that is factory preset. If an adjustment is necessary please follow the instructions listed below. Figure 5. Thermostat Adjustment Procedure (GRMW-3 and GRMW-4 only) DRAWER OPERATION 1. Open product holding drawer by gently pulling drawer handle outward. As the drawer moves out the access door automatically opens. [. . . ] Portland PENNSYLVANIA Elmer Schultz Services Philadelphia 215-627-5401 FAST Comm. Service Philadelphia 215-288-4800 GCS Service Pittsburgh 412-787-1970 717-236-9039 610-376-5444 503-231-7171 503-624-0890 419-385-9121 518-563-3200 315-422-9271 Armstrong Repair Service Houston 713-666-7100 Commercial Kitchen Repair Co. San Antonio 210-735-2811 UTAH La Monica's Rest. Service Murray 801-263-3221 VIRGINIA Daubers Norfolk Daubers Springfield WASHINGTON Restaurant Appl. [. . . ]