User manual HATCO GRPWSM-1001

[. . . ] GLO-RAY® Pizza Warmer GRPWS Series Installation & Operating Manual I&W #07. 05. 102. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] (36 kg) to be either sealed or raised on the installation surface. CAUTION Some exterior surfaces on the unit will get hot. Use caution when touching these areas to avoid injury. ON/OFF Switch Thermostat Control Figure 6. GRPWSM-1001 6 MAINTENANCE GENERAL Hatco Glo-Ray Pizza Warmers are designed for maximum durability and performance, with minimum maintenance. WARNING To avoid any injury, turn the power switches off, unplug the unit from the power source and allow to cool before performing any maintenance. WARNING To avoid electrical shock or personal injury, do not steam clean or use excessive water on the unit. Do not operate if it has been submerged in water. WARNING Only light bulbs which meet or exceed N. S. F. standards, specifically designed for food holding areas must be used. Breakage of light bulbs not specially coated could result in personal injury and/or food contamination. WARNING If service is required on this unit, contact your Authorized Hatco Service Agent, or contact the Hatco Service Department at 800-558-0607 or 414-671-6350; fax 800-690-2966 or International fax 414-671-3976. WARNING This product has no "user" serviceable parts. To avoid damage to the unit or injury to personnel, use only Authorized Hatco Service Agents and Genuine Hatco Replacement Parts when service is required. WARNING Genuine Hatco Replacement Parts are specified to operate safely in the environments in which they are used. Some aftermarket or generic replacement parts do not have the characteristics that will allow them to operate safely in Hatco equipment. It is essential to use Hatco Replacement Parts when repairing Hatco equipment. Failure to use Hatco Replacement Parts may subject operators of the equipment to hazardous electrical voltage, resulting in electrical shock or burn. CLEANING CAUTION Use only non-abrasive cleaners. Abrasive cleaners could scratch the finish marring its appearance and making it susceptible to dirt accumulation. To preserve the bright finish of the Glo-Ray Pizza Warmer, it is recommended that the exterior and interior surfaces be wiped daily with a damp cloth. Stubborn stains may be removed with a good non-abrasive cleaner. Hard to reach areas should be cleaned with a small brush and mild soap. Clean the glass sides using a common glass cleaner. DISPLAY LIGHT BULB REPLACEMENT The display light is an incandescent light bulb which illuminated the warming area. [. . . ] Oklahoma City 405-528-8883 OREGON Bressie Electric Co. Portland 503-231-7171 503-624-0890 PENNSYLVANIA Authorized Factory Service Coraopolis 412-262-2330 FAST Comm. Service Philadelphia 215-288-4800 GCS Service, Inc. Pittsburgh 412-787-1970 K & D Service Co. [. . . ]