User manual HATCO GRSDM-0903

[. . . ] GLO-RAY ® Merchandising Display Warmer GRSDH, GRSDS & GRSDS/H Series Installation & Operating Manual I&W #07. 05. 011. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Installing Product Divider Bars Figure 6. Side Glass Panel Installation Figure 5. Leg Installation are susceptible to active air movements or currents should be avoided, i. e. , near exhaust fans or hoods and air conditioning ducts. WARNING For safe and proper operation, the unit must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. CAUTION To avoid any injury or damage locate the unit at the proper counter height, in an area that is convenient for use. The location should be level to prevent the unit or its contents from accidentally falling, and strong enough to support the weight of the unit and food displayed. LOCATION NOTE: Unit must be transported in the upright position. For proper operation and maximum performance, locate the Merchandising Display Warmer in an area where the ambient air temperature is constant and is a minimum of 70°F (21°C). GRSDM-0903 OPERATION The Merchandising Display Warmer main power is controlled by the ON/OFF toggle switches. Each switch must be in the ON position for the unit to function. The thermostat controlled base can be set to any desired heating level as indicated on the control plate. NOTE: Main power toggle switch must be in the ON position for the heated base to function. NOTE: If the unit is equipped with LED Temperature Controls, see ACCESSORIES for operation. CAUTION Some exterior surfaces on the unit will get hot. Use caution when touching these areas to avoid injury. WARNING For safe and proper operation do not place food product directly onto hardcoat surface. Food product must be wrapped, boxed or on a food pan. For safe and proper operation locate the unit indoors where the ambient air temperature is constant and is a minimum of 70°F (21°C). ON/OFF Toggle Switch Thermostat Control Figure 8. Controls 80°F 28°C 200°F 93°C Form No. GRSDM-0903 12 MAINTENANCE GENERAL Hatco Glo-Ray® Merchandising Display Warmers are designed for maximum durability and performance, with minimum maintenance. WARNING To avoid any injury, turn the power switch OFF, unplug the unit from the power source and allow to cool before performing any maintenance. WARNING To prevent any injury, discontinue use if power cord is frayed or worn. [. . . ] San Francisco COLORADO Hawkins Commercial Appliance Englewood 303-781-5548 DELAWARE Food Equipment Service Wilmington 302-996-9363 FLORIDA Whaley Foodservice Repair Jacksonville 904-725-7800 Nass Service Co. , Inc. Pompano Beach 954-971-0456 650-635-1900 Electrical Appl. Repair Service Independence 216-459-8700 E. Oklahoma City 405-235-2184 Krueger, Inc. [. . . ]