User manual HATCO HLM-0299

[. . . ] and the words WARNING or CAUTION printed in bold face are important. Warning means there is the possibility of personal injury to yourself or others. Caution means there is the possibility of damage to the unit. Your Hatco Display Light is a product of extensive research and field testing. [. . . ] For correct installation, provide supply wires rated for at least 90° C (194° F) from a properly sized fused disconnect or circuit breaker conforming to local electrical codes. Use UL recognized wire nuts rated for at least 90° C (194° F) and properly sized for connection. Consult a local licensed electrical contractor if you have any questions on proper installation. Refer to the Electrical Rating Chart for specific information. Figure 4. Adjustable Bracket Mounting OPERATION Turn the toggle switch to the ON position. Printed February 1999 3 Form No. HLM-0299 MAINTENANCE CLEANING The Hatco Display Light is designed for maximum durability and performance, with minimum maintenance. WARNING To avoid any injury, turn the power switch off, unplug the unit from the power source and allow to cool before performing any maintenance. CAUTION The Display Light is not waterproof. Do not operate if it has been submerged in water. To preserve the finish of the Hatco Display Light, it is recommended that the surfaces be wiped daily with a damp cloth. Stubborn stains may be removed with a good non-abrasive cleaner. Abrasive cleaners could scratch the finish of your Glo-Rite Display Light, marring its appearance and making susceptible to dirt accumulation. DISPLAY LIGHT BULB REPLACEMENT The display light is a shatter-resistant, incandescent light bulb which illuminates the area. The bulb has a special coating to guard against injury and food contamination in the event of breakage. To replace a light bulb, disconnect the power supply and wait until the unit has cooled. Unscrew the light bulb from the unit and replace it with a new specially coated incandescent bulb. NOTE: Hatco shatter-resistant light bulbs meet N. S. F. standards for food holding and display areas. For 120 Volt applications, use Hatco part #02. 30. 043. 00. WARNING Only light bulbs which meet or exceed N. S. F. standards, specifically designed for food holding areas must be used. Breakage of light bulbs not specially coated could result in personal injury and/or food contamination. Figure 5. Light Bulb Printed February 1999 4 Form No. [. . . ] Austin 512-719-4445 Stove Parts Supply Fort Worth 817-831-0381 Armstrong Repair Service Houston 713-666-7100 Commercial Kitchen Repair Co. San Antonio 210-735-2811 San Antonio Rest. San Antonio 210-824-3271 UTAH Peterson's Commercial Parts & Svc. Salt Lake City 801-487-3653 VIRGINIA Daubers Norfolk Daubers Springfield 757-855-4097 703-866-3600 WASHINGTON Restaurant Appl. [. . . ]