User manual HATCO TF1946M-1004(2)

[. . . ] THERMO-FINISHERTM Food Finisher TF-1900 & TF-4600 Series Installation & Operating Manual I & W #07. 05. 117. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Values change by 1 second every time an arrow key is pressed. Press the ENTER button when you have reached the desired setting. Press the Numbered Program Selection button selected in step 3 to enter all the settings into memory. IMPORTANT NOTE: If no adjustments are made within 15 seconds, the controller will revert back to the "READY" mode and will not accept any changes. Also, pressing any of the other Numbered Program Selection buttons will take the unit out of the programming mode without accepting any changes. If ready to finish food, place product in unit on center of metal rack and press desired Numbered Program Selection button. 10. Using a grease pencil or "China" pencil, record the specific menu item on the control panel next to the selected Numbered Program button. Repeat steps 3-10 for the other Program buttons. NOTE: All units keep the power and timing settings in memory, even when the unit is turned off or is unplugged from the power source. PROGRAMMING CONTROLLER 7A 7B 7C UPPER HEAT LOWER HEAT 1 2 3 4 5 7D 7E 7F 7G Figure 7. Programming a Selection 9 Form No. TF1946M-1004 PROGRAMMING CONTROLLER IDLE MODE The Thermo-FinisherTM features an "Idle" mode. Once the unit reaches the mode, the upper heating element(s) automatically go into a programmed idle power setting. (The display will still show during the idle mode). The unit will stay in this mode until one of the five Program buttons is pressed, or the unit goes into auto-shut off. NOTE: Begin by setting the idle mode power setting at 30% and adjust the program accordingly to achieve optimum performance. To change the idle mode power setting, follow these steps: 1. Press and hold the UP arrow while, at the same time, press and hold the ENTER button for three seconds. The display will show the current programmed power value (Figure 8A). To adjust the idle mode, press either the UP or DOWN arrow until you reach the desired setting (Figure 8B). Each time you press an arrow, the setting will change by 10. To accept the new value, push the ENTER button a second time (Figure 8C). Note: If no adjustments are made within 15 seconds, the controller goes back to its original settings without accepting the change. [. . . ] Harrisburg 412-787-1970 717-236-9039 610-376-5444 503-231-7171 503-624-0890 405-528-8883 419-385-9121 518-563-3200 315-422-9271 Armstrong Repair Service Houston 713-666-7100 Commercial Kitchen Repair Co. San Antonio 210-735-2811 San Antonio Rest. San Antonio 210-532-1660 UTAH La Monica's Rest. Service Murray 801-263-3221 VIRGINIA Daubers Norfolk Daubers Springfield WASHINGTON Restaurant Appl. [. . . ]