User manual HATCO TF2OM-0603

[. . . ] THERMO-FINISHERTM Food Finisher TF 2000 Series Installation & Operating Manual I & W #07. 05. 110. 00 1 2 3 4 5 OFF POWER ON This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] TF20M-0603 PROGRAMMING CONTROLLER IDLE MODE The Thermo-FinisherTM features an "Idle" mode. Once the unit reaches the rEdY mode, the upper heating element(s) automatically go into a programmed idle power setting. (The display will still show rEdY during the idle mode). The unit will stay in this mode until one of the five Program buttons is pressed, or the unit goes into auto-shut off. NOTE: Begin by setting the idle mode power setting at 20% and adjust the program accordingly to achieve optimum performance. To change the idle mode power setting, follow these steps: 1. Press and hold the UP arrow while, at the same time, press and hold the ENTER button for three seconds. The display will show the current programmed power value (Figure 8A). To adjust the idle mode, press either the UP or DOWN arrow until you reach the desired setting (Figure 8B). Each time an arrow is pressed the setting will change by ten. To accept the new value, push the ENTER button a second time (Figure 8C). NOTE: If no adjustments are made within 15 seconds, the controller goes back to its original settings without accepting the change. Pushing any of the numbered program buttons will also take the controller out of programming mode without accepting the change. To adjust the Auto-Off time push either the UP or DOWN arrow until you reach the desired setting (Figure 9B). The Auto-Off mode can be adjusted from "0" (indicating unit will not turn off) to 60 minutes until turn off time, in single minute increments. To accept the new Auto-Off time value, push the ENTER button a second time (Figure 9C). NOTE: If no adjustments are made within 15 seconds the controller goes back to its original settings without accepting the change. Pressing any of the numbered buttons will also take the controller out of programming mode without accepting the change. To get the unit out of the Auto-Off Mode, push any one of the five numbered program buttons and the unit will begin operating. PROGRAMMING HINTS: · On menu items in which internal temperatures are critical (such as chicken or pork), the primary heat source comes from the bottom. On menu items in which the surface temperatures are critical (such as cheese melting), the primary heat source comes from the top. See Recommended Food Finishing Guide for specific menu examples. · When performing product testing, heat three plates with the same food product in succession. [. . . ] San Francisco COLORADO Hawkins Commercial Appliance Englewood 303-781-5548 DELAWARE Food Equipment Service Wilmington 302-996-9363 FLORIDA Whaley Foodservice Repair Jacksonville 904-725-7800 Nass Service Co. , Inc. Pompano Beach 954-971-0456 650-635-1900 Electrical Appl. Repair Service Independence 216-459-8700 E. Oklahoma City 405-235-2184 Krueger, Inc. [. . . ]