User manual HATCO TQ2M-1005(1)

[. . . ] Toast Qwik® Electric Conveyor Toasters TQ-10, TQ-15, TQ-400, TQ-800, TQ-1200, TQ-1800 Series Installation & Operating Manual I&W #07. 05. 124. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] CAUTION When setting up the unit for operation, make sure power to the unit is off and the toaster is at room temperature. Failure to do so could result in personal injury. Figure 6. Toast Feed Ramp TOAST FEED RAMP The toast feed ramp is installed at the factory and can be used in two positions. When in the upright position, the toaster is set for automatic feed. Bread products enter the toaster by placing them on the feed ramp and releasing. For manual feeding of product, tip the feed ramp until it rests on top of the unit. In this position bread products can be manually loaded by placing directly on the conveyor belt. CAUTION Some exterior surfaces on the unit will get hot. Use caution when touching these areas to avoid injury. Toast Crumb Tray Figure 7. Toast Crumb Tray Stop Pins TOAST CRUMB TRAY Install toast crumb tray directly below the conveyor belt and below the stop pins. Insert until the front of the crumb tray meets the stop pins. CAUTION To avoid damage to the unit or injury to personnel always operate toaster with crumb tray installed. CAUTION To avoid any injury, do not remove the crumb tray for cleaning until toaster is cool. 9 Form No. TQ2M-1005 INSTALLATION FRONT OR REAR DISCHARGE Toast-Qwik® units can be set up so toasted product discharges at either the front or the rear of the unit. WARNING To assure safe and proper operation while operating in the Front Discharge mode, allow a minimum clearance of 1" (25 mm) along the sides and rear. Allow a minimum clearance of 12" (305 mm) along the front. WARNING To assure safe and proper operation while operating in the Rear Discharge mode, allow a minimum clearance of 1" (25 mm) along the sides. Allow a minimum clearance of 12" (305 mm) along the front and rear. TQ-10 & TQ-15 MODELS ONLY The TQ-10 & TQ-15 models use a one piece discharge chute/collector pan. The installation location determines discharge area. For front discharge install toaster chute from the front of the toaster with the curved end inward and the rear lip of the chute on the rear most pins. For rear discharge install toaster chute from the rear of the toaster with the curved end in, and the lip of the chute over the inside set of pins. [. . . ] Repair Service Independence 216-459-8700 E. Oklahoma City 405-235-2184 Krueger, Inc. Oklahoma City OREGON Ron's Service, Inc. Portland PENNSYLVANIA Elmer Schultz Services Philadelphia 215-627-5401 FAST Comm. [. . . ]