User manual HAUCK ONTARIO

[. . . ] WARNING: Remember that small parts can be swallowed by your child and can cause choking. WARNING: overloading, incorrect folding and use of non-approved accessories may damage or break this pushchair. WARNING: It may be unsafe to use accessories, e. WARNING: It may be unsafe to use replacement parts other than those supplied or approved by the manufacturer or distributor. [. . . ] The backrest can be altered to 3 different positions. 7A-7C) Install the front bar by fixing it onto the 2 sides of the catches (7a). Test the front bar by pulling on it to make sure it is locked to place. To release the front bar, release the clip at the catches and pull the front bar out (7b). The front bar can also be adjusted to the desired position by pressing the buttons on both sides (7c). 8A-8C) Pull both plastic catches (left & right) upwards to release the handle position (8a). Release the 2nd safety lock (8b) and then swivel the handle to the opposite direction (8c). Please always check if the handle has engaged in the new position completely. Front & rear wheels must be additionally secured with both of the parking brakes when parking the stroller, if the handle is in the position facing towards the child. 10A-10D) Make sure the handle is at the canopy side, and the backrest is in the lie down position. Press the 2 nd lock button down first (10a), then pull the folding levers, on both sides, upwards (10b), push the handle bar to the front and let the stroller collapse (10c). Ensure the stroller is closed by the transportation lock on the side of the frame (10d). SECURE THE CHILD IN THE SEAT (fig 11): Place the child in the seat and push the clips on the waist belt into the buckle on the crotch belt (the one that comes between the child's legs). adjust the length of the belt to your child's needs. Always ensure the straps are not twisted or caught on the stroller frame. Check the adjustment every time you place the child in the seat and when the backrest is reclined. to release the harness , squeeze & open the buckle. Harness adjustment: Insert both fasteners (B) into the buckle (A), ensure that both buttons click into position. Ensure both shoulder straps (C) are attached to the fasteners (B). Each strap has its own length adjuster (D). to undo the harness , press the button and pull apart. "D" Rings are provided for fitment of a full safety harness. [. . . ] The cover should be air-dried, but not exposed to excessive sunshine. Please do not dry the cover in the drier, to avoid shrinking. Do not re-fit the covers until they are completely dried. Cleaning the frame Dry the pushchair with a soft cloth after cleaning or after use rain or snow. [. . . ]