User manual HAUPPAGE WINTV-HVR-1100/1300 QI

[. . . ] Avoid this by contacting the earthed chassis of your PC, before you open it or touch the pci card. Locate a free PCI slot (a short white slot). Unscrew and remove the metacover plate which covers the back of the empty slot. Plug the WinTV-HVR board into the PCI slot, and screw the WinTV HVR metal cover plate to the PC. [. . . ] While in the Pause mode, hitting the Replay button acts like the Instant Replay you see on TV broadcast sporting events: the audio/video goes back in time and you repeat what you have previously seen. Each click of the Replay button causes audio/video to go back 10 seconds. For example, if you want to repeat the audio/video you saw 10 seconds ago, you would click the Replay button once. If you want to see the video you saw one minute ago, you would need to click the Replay button six times. For extended replay times, you might find it more convenient to grab the Video Position indicator control bar and move it to the left. Once you let the control bar go, audio/video starts to play (it might take a few seconds for the WinTV application to start playing). Play forward slow If you click Record button more than once, a record timer will be set and the recording will be done for 15 minutes for each time the Record button is clicked. For example, if you click the button 3 times, the WinTV will record for 30 minutes. In the File menu you can: Rename your recorded video file: To rename a video file, find the file you would like to rename, highlight it with your mouse, and click and hold the right mouse button. Go down to Rename and then you can type in a new name. Remember: you must keep the MPG extension on the file. Play a video file previously recorded: Find the file you would like to play, highlight it with your mouse (one click of the mouse button) and click Open. Delete recorded video files which you no longer want: Click your right mouse button on the video file once, go down the menu and click Delete. WinTV-Scheduler works by using the Windows Task Scheduler to launch WinTV at the chosen time. WinTV-Scheduler sets up a command line in Task Scheduler to run WinTV, specifying a TV channel and a length of time to record. Ote: You cannot access the Wing settings until you have purchased the optional transcoder software, for more informations see www. When recording TV, the record button will depressed A time counter will be shown indicating the lenght of time of the recording Once these are set, click Set Program. You can add more Events, clicking Set Program after each event is set. The WinTV program does not have to be running for the Schedular to work, but your PC needs to be either turned on, in Standby or in Hibernate Mode, but you should not be logged off. If WinTV is not running, it takes about 10 seconds to start WinTV and to start the recording of TV. You should see an icon of a globe close to the Windows clock. Once the scanning is complete you will be able to see the EPG guide: VTPlus sophisticated analogue Teletext software application which is only available on the analogue Tuner of the HVR. [. . . ] If you now select OK a black screen will briefly appear and once it has disappeared the software will be removed. If you now re-start the computer you will be at Step 3 on page 3 of this document and can now re-install the software. In the WinTV Channel Manager, click on Sources then DVB-T Source, enter the LCN numbers into the space under Channel Number and click on the Tune button. The channel number will then be scanned and any channels found will be listed in the channel list below. [. . . ]