User manual HAUPPAGE WINTV-HVR-3000 QI

[. . . ] To start the WinTV2000 software installation, click Start / Run then type your CD-ROM drive letter (for example: D:\) and then Setup. It is recommended to leave the default components ticked and select Install and follow the on screen instructions. Ote: You may need to disable your antivirus programs during the installation only. Avoid this by contacting the earthed chassis of your PC, before you open it or touch the PCI card. [. . . ] After installation, WinTV-Scheduler can be found by going to Start / Program Files / Hauppauge WinTV. WinTV-Scheduler works by using the Windows Task Scheduler to launch WinTV at the chosen time. WinTV-Scheduler sets up a command line in Task Scheduler to run WinTV2000, specifying a TV channel and a length of time to record. To set up an event for timed watching or recording, run WinTVScheduler and click on the Add Program. Ote: You cannot access the Wing settings until you have purchased the optional transcoder software, for more informations see www. Clicking the Pause button while Playing will pause your audio/video. It takes about 10 seconds for the Replay Buffer to be initialized and for Pause to become effective. Unclicking the Pause button will cause the audio/video program to start playing from the point where the button was originally clicked. Most WinTV2000 functions are active while in the Pause or Pause Live mode. For example, you can change volume, resize the TV window, go into "no-title mode", etc. While in Pause mode, the Video Position bar shows the amount of the Replay Buffer which is filled with video. For example, if the Video Position indicator shows halfway, it means that half of the Replay Buffer is filled. If you find you cannot Pause as many minutes as you would like, increase the size of the Replay Buffer. While in Pause mode, the A/V stream is always saved in the Replay Buffer. Clicking the Fast Forward button two times will fast forward your video at 8X speed. Clicking the Rewind button again will continue the playing of the video. If you are using a external source like a Hi-8 Camcorder, Video recorder etc, then you will need to connect via the S-Video/Composite for the Video picture and Line-Input for the sound. If you are using a Scart to composite (RCA Yellow phono) lead, please ensure that the signal is being sent in the correct direction from the Scart lead to the phono connection. A scart to S-Video lead, in most cases, will not work correctly and will only give you a black and white picture. Clicking the Fast Foward button two times will fast foward your video at 8X speed. Clicking the button again will continue playing back at normal speed. Clicking the Slow Motion button during playback will cause the video to play in slow motion. [. . . ] If you now re-start the computer you will be at Step 5 on page 3 of this document and can now re-install the software. "Error code 10" during installation This is caused by a failure to load the WinTV-HVR-3000 drivers. Uninstall the software (as above) and then follow the instructions from page 3. If this still gives you an error message move the WinTV-HVR3000 to a different PCI slot and re-install the drivers again. [. . . ]