User manual HAWKING HAWNU1

[. . . ] USER'S MANUAL HI-GAINTM WIRELESS-150N USB NETWORK ADAPTER with RANGE AMPLIFIER website www. hawkingtech. com e-mail techsupport@hawkingtech. com tech support 1-888-202-3344 © COPYRIGHT 2010 HAWKING TECHNOLOGIES, INC. ALL RIGHTS RESERVED. HAWNU1 LIMITED WARRANTY Hawking Technology guarantees that every HAWNU1 Hi-Gain Wireless-150N USB Adapter with Range Amplifier is free from physical defects in material and workmanship under normal use for one (1) year from the date of purchase. If the product proves defective during this two-year warranty period, call Hawking Customer Service in order to obtain a Return Authorization number. Warranty is for repair or replacement only. [. . . ] Please make sure the access point you wish to connect is displayed. If not, please click `Rescan' few more times. You can also click `Information' button to see the detailed information about selected access point. Start PBC pairing procedure at access point side (please refer to the instruction given by your access point's manufacturer), then click `PBC' button in wireless configuration utility to start to establish wireless connection by WPS. Please be patient (This may require several seconds to one minute to complete). When you see `WPS status is connected successfully' message, means the connection between this wireless network card and access point is successfully established by WPS, and the information about access point you connected to will be displayed. You can click `Detail' button to see detailed information of connected access point. If you wish to save this connection as a profile, you can click `Export Profile' button, and this connection will be saved. You can find this connection in `Profile' tab in a later time. Sometime WPS may fail (In the following picture, WPS pairing failed because no WPS-enabled access point is found): 36 You can click `PBC' button few more times to try again. When an access point is connected, you can click `Disconnect' to disconnect your wireless network card from a connected access point, or select another WPS-enabled wireless access point, then click `Connect' to establish connection to selected access point, if there are more than one WPS-enabled access point found. You can also click `Rotate' button, and next access point on the list will be selected to establish connection. If you want to delete a found access point from the list, select it and click `Delete' button. WPS Setup - PIN If the wireless access point you wish to connect supports PIN, please follow the following instructions to establish connection to it: 1. Right-click the Hawking configuration utility icon located at lower-right corner of computer desktop and then click `Launch Config Utility'. 2. Click `WPS Configuration' menu, and the following settings will appear. 37 3. The PIN code of your wireless network card is an eight-digit number located at the upper-right position of configuration utility. Remember it then input the number to your wireless access point as the WPS PIN code . (Please refer to the user manual of your wireless access point for instructions about how to do this). NOTE: If you experienced problem with the pin code provided here, you can click `Renew' to get a new pin code. Click `PIN' button now, and wait for few seconds to one minute. If a wireless access point with correct PIN code is found, you'll be connected to that access point. [. . . ] The longer the chip is, the greater the probability that the original data can be recovered. Even if one or more bits in the chip are damaged during transmission, statistical techniques embedded in the radio can recover the original data without-the need for retransmission. To an unintended receiver, DSSS appears as low power wideband noise and is rejected (ignored) by most narrowband receivers. Spread Spectrum technology is a wideband radio frequency technique developed by the military for use in reliable, secure, mission-critical communication systems. [. . . ]