User manual HAWKING HPS3P

[. . . ] FCC Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to subpart J of Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which the user will be required to correct the interference at their own expense. [. . . ] Enter a priority number for the queue service, or press Enter to accept the default. 24. Repeatedly press Escape to exit the PCONSOLE program. 25. Reset the print server to have the changes take effect. NOTE: If the print server you have is with multiple printer connectors, you may create multiple print queues and printer objects. Your print server should now be ready to use. You should be able to redirect printing to your print server using a CAPTURE command like the one shown in the previous section. 5. 2. 2. 2 Configuring as a Remote Printer Mode The remote printer feature is not available for some print server models. Make sure that you have created the NetWare print server with Type Remote using PCONSOLE utility before you configure the print server. For more detailed information about PCONSOLE, please refer to NetWare's manual. You can set up the NetWare print server and print queue objects by following the steps below: 1. Change the current file server, if necessary, using the Change Current File Server menu selection. Choose the "Print Queue" Information menu selection. Press the Insert key to add a new print queue. Type in a print queue name, like "PQ" or "Q1". 6. You have now successfully created the print queue that your NetWare print server will serve. Press the Escape key until the Available Options main menu is displayed. Select "Print Server Information. " 8. Press the Insert key to add a new NetWare print server. Press Enter to select the newly created print server. Select "Print Server Configuration. " Select "Printer Configuration. " 12. Select Printer 0 (or Printer 1, Printer 2), press Enter, and then select Remote Parallel in the Type field. 13. Press Escape, and answer Yes to the Save Changes question. Select Queues Serviced by Printer, then select Printer 0 and press Enter. 15. Press Insert and add your newly created print queue to the list of queues serviced by the printer. Enter a priority number for the queue service, or press Enter to accept the default. 16. [. . . ] Press the "Write" button then the "Reset" button to finalize. 9. 3. 2 Client User Side At first, please confirm that the client computer has installed and setup the TCP/IP protocol correctly. 9. 3. 2. 1 Send an Email directly to the email account serviced by the print server. You can send a text document directly to the print server mailbox and have it print out. Please note that the email recipient should be the email address serviced by the Print Server. The Print Server will automatically retrieve the email from the email box and print it to the attached printer. 10. IPP Printing 10. 1 Introduction The IPP (Internet Printing Protocol) provides you with a convenient method for remote printing jobs via the TCP/IP protocol. The HPS3P 3 Parallel Port 10/100M Print Server can support IPP printing capabilities. [. . . ]