Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual HAYES DISC BRAKES 45-18052ECMC REPAIR. We hope that this HAYES DISC BRAKES 45-18052ECMC REPAIR user guide will be useful to you.
Lastmanuals help download the user guide HAYES DISC BRAKES 45-18052ECMC REPAIR.
Manual abstract: user guide HAYES DISC BRAKES 45-18052ECMC REPAIR
Detailed instructions for use are in the User's Guide.
[. . . ] Improper installation could cause severe or fatal injuries. Warning: When following any of the procedures below, be sure to keep your hands and fingers from getting caught in the disc. Failure to do so could result in injury. Warning: With use, disc brake components may become very hot. [. . . ] Using a 2. 5mm Allen wrench, turn the push rod clockwise until it is removed from the adjuster bushing and the thread retention bushings.
C. Put the adjuster bushing and thread retention bushings into the hole in the lever. Using a 2. 5mm Allen wrench, thread the push rod through the hole in the bushing. Firmly push the reach adjustment knob onto the end of the push rod. Note: Be sure it securely snaps over the retaining ring. Put both plastic lever bushings into the lever, and then slide the lever into place. Line up the washers with the hole in the lever and the holes in the master cylinder body. Drop the pivot pin through the body, lever bushings, and lever hole. Tighten the 2. 5mm Allen heads bolts until tight.
D. Master Cylinder Piston
Note: it is not necessary to remove the hose from the master cylinder 1. Remove the push rod, master cylinder piston, and spring by removing the snap ring and washer using a snap ring tool. DO NOT attempt to take the rubber seals off of the master cylinder piston. Warning: Always wear safety glasses when removing a snap ring. Clean and inspect the inside of the master cylinder and all parts. Replace those parts that are damaged with new service parts. Thoroughly clean all of the parts by spraying them with isopropyl alcohol and wiping them with a clean rag. Begin reassembly by dropping the spring and master cylinder assembly into the lever body. Place a small amount of the yellow Versilube onto the ball end of the pushrod. Install the ball end of the threaded push rod into the master cylinder piston. Push on the threaded push rod to assure that all parts are properly in place. [. . . ] Replace those parts that are damaged with new service parts. Thoroughly clean all parts by spraying them with isopropyl alcohol 1 and wiping with a clean rag. Place the bladder into the master cylinder body. Install reservoir cap and secure with the two T-10 Torx bolts. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE HAYES DISC BRAKES 45-18052ECMC REPAIR
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual HAYES DISC BRAKES 45-18052ECMC REPAIR will begin.
