User manual HECO CENTER 4

[. . . ] Strip 10 ­ 15 mm of insulation from the ends of the cables. Twist the ends ­ this is much better than tinning them with solder ­ insert them in the terminals and tighten the terminal screws firmly (fig. Loudspeaker cables with CE-compliant banana or single-pin plugs (4 mm) or forked fittings can also be used. [. . . ] this will prevent excessive emphasis of the bass range. Celan XT 301: shelf loudspeakers should also be as free-standing as possible, the distance to the sides and rear to walls and items should be at least 10 cm, the tweeters should be located at ear height. You should use the supplied spikes when setting the speakers up. This isolates them from the supporting surface, preventing unpleasant resonance effects. You can choose between metal and hard rubber spikes for the standing speakers, while the enclosed hard rubber spikes are used for the shelf speakers. The spikes are screwed into the threaded bushes on the bottom of the speaker. The HECO Celan XT loudspeakers are ideal for use with the Celan XT Sub 32A active subwoofer. HECO CELAN XT 301, 501, 701 AND 901 AS A FRONT OR REAR LOUDSPEAKER The front loudspeakers are positioned at ear height on the left and right as equidistant from the television as possible. The rear loudspeakers are placed at ear height or a little above on the left and right besides or better behind the listening position. Celan XT 301: if possible, the cross-over frequency for the front and rear channels should be adjusted to approximately 80 Hz in the AV receiver's set-up. Otherwise all the recommendations made in the previous chapter also apply. hECO CELAN XT CENTER 4 The Celan XT Center 4 loudspeaker visually and acoustically ideally matches the other Celan XT models. The loudspeaker is placed immediately on or under the television set. HOW TO AVOID DAMAGE TO YOUR VALUABLE SPEAKERS All HECO loudspeakers are designed and built for optimum sound reproduction with the tone controls in the central position ­ i. Turning up the bass and treble controls too far delivers more power to the woofers and/or tweeters, and at high volumes this can actually destroy the speaker units!If the output of your amplifier is significantly higher than the rated power handling capacity of your speakers extremely high volumes can physically destroy your speakers. [. . . ] The guarantee period is not altered by the fact that we have carried out guarantee work. Unauthorized tampering with the equipment will invalidate this guarantee. Consult your authorized dealer first, if guarantee service is needed. [. . . ]