User manual HEIDENHAIN ND 1100 V2.15.0 QUICK REFERENCE GUIDE

[. . . ] Caution Do not connect encoders or other equipment to the ND 1100 when the power is on. 8 Audio out, for 3, 5 mm headphone /speaker jack, monaural, 8 Ohm USB type A interface for printer or data storage Remote accessory interface RJ-45 for optional foot switch or keypad accessory. Two optional remote accessories can be used simultaneously using an RJ-45 splitter. [. . . ] Measurement scaling Linear measurement scaling can be applied when measuring parts that expand or shrink. Press the MENU soft key, press the SETUP soft key and then navigate to the SCALE FACTOR screen. Enter the desired MULTIPLIER, highlight the ACTIVE field and press the YES soft key to enable scaling. Press the MENU soft key, press the SETUP soft key and then navigate to the DISPLAY SCREEN. Enter the desired display resolutions and other parameters. Note: Many more setup functions are available beyond the minimum parameters discussed here. A current probe position can be zeroed or preset to a value and then used as a datum. Zero a position Move the crosshairs or touch probe to the desired datum position and press an AXIS key to zero the position on the corresponding axis. Move the crosshairs or touch probe to the desired datum position and press the PRESET soft key. Use the ARROW CURSOR keys to navigate to the SUPERVISOR setup screen. Highlight the PASSWORD field, enter the password and then press the ENTER key. Position is probed with crosshairs or with a touch probe. Probing with crosshairs Move the stage to position the crosshairs over the desired point. Move the touch probe to the desired point. [. . . ] Choose a MASTER AXIS, enter the calibration artifact ANGLE, and press the TEACH soft key. Select a unit of measure Press the IN/MM soft key to toggle between inches and mm. Select a datum Press the ABS/INC soft key to toggle between absolute and incremental datum. [. . . ]