User manual HELIX DXP-6

[. . . ] This is performed by means of the fixing screws screwed into a mounting surface offering sufficient retention and stability. Before drilling the holes for the screws, carefully examine the area around the installation position and make sure that there are no electrical cables or components, hydraulic brake lines or any part of the petrol tank located behind the mounting surface - otherwise these could be damaged. You should be aware of the fact that such components may also be concealed in the double-skin trim panels/mouldings. General instruction for connecting the digital crossover The HELIX DXP-6 may only be installed in motor vehicles which have a 12-volt minus pole connected to the chassis ground. [. . . ] 1Setup Mode The following adjustments can carried out in the Setup-Mode: - INPUT LEVEL SETUP (only analog) - CHANNEL SETUP - BASS EQ SETUP 8. 1 Input Level Setup Using the key INPUT LEVEL the respective menu can be chosen. Via the keys UP and DOWN the Input Level can be adjusted. 1Control Unit Via the Control Unit the Digital Crossover HELIX DXP-6 can be operated in three different control modes: - NORMAL MODE - SETUP MODE - TEST TONE MODE The respective channel has to be chosen with the keys MENU+ und MENU­. If there is no clipping, the HELIX diamond is not filled out. 2 Channel-Setup By using the the CHANNEL key, the respective menu can be selected. The output channels which have to be adjusted can be selected via the keys CH+ and CH­. Please chose the desired function for each channel with the keys MENU+ and MENU­. The respective settings can be made with the keys UP and DOWN. the menu DELAY TIME provides the possibility to change the displayed unit. Use the key BASS EQ/ SLOPE/ DELAY to select between ms / cm / inch. Use the key BASS EQ/ SLOPE/ DELAY for the filter settings. The edge steepness can be adjusted between 12 or 24dB. 3 Test Tone Mode The HELIX DXP-6 has a Test-Tone-Mode (white noise) in order to test the loudspeaker connections and the balance settings of each channel. Use the key TEST TONE to select the mode. The channel which shall be tested can be selected via the keys CH+ and CH­. Use the keys UP and DOWN to adjust the testtone-level. Use the keys ESC or TEST TONE to quit the Test-ToneMode. 9 Default Settings in order the restore the default settings of HELIX DXP-6, press the ESC key for 5 seconds. Confirm the reset process with the key MENU+ (=Y=yes). [. . . ] 4) Consult your authorized dealer first, if warranty service is needed. Should it be necessary to return the product to the factory, please ensure that a) the product is packed in original factory packing in good condition b) the warranty card has been filled out and attached to the product c) the product is shipped prepaid, i. At your expense and risk d) the receipt/invoice as proof of purchase is enclosed 5) Excluded from the warranty are: a) Shipping damages, either readily apparent or concealed (claims for such damages must be immediately notified to the forwarding agent). B) Scratches in metal parts, front panels or covers etc. [. . . ]