User manual HELIX PRECISION P

[. . . ] This is especially important if any hole cutting is required. Complete speaker, mounting size and depth requirements can be found at the end of this manual. A good way to confirm speaker place meet on a door or body panel is to place the speaker's die cast mounting ring onto the surface. [. . . ] If you choose to perform your own installation read the following information and precautions carefully. Failure to follow the stated precautions may result in personal injury and/or damage the audio system or vehicle. Mounting panel reinforcement may be necessary in some cases in order to prevent surface flex. This can be achieved by mounting the speaker on a metal or wooden sub-baffle behind the body or door panel. Consult an installation specialist for further direction. Unless you are replacing existing speakers of same size, mounting locations will have to be cut into the doors, body panels, or rear deck. In some cases speaker mounting holes will be precut in the doors, body panels, or rear deck steel. Due to their structural integrity and accessibility. These precut mounting holes should be used whenever possible. IMPORTANT: Never cut any metal that is an integral part of an automobile's safety or structural supportsystem. HELIX PRECISION Speaker Installation NOTE. HELIX strongly recommends that you operate the complete audio system at low volume before final installation of your HELIX PRECISION automotive loudspeakers. This will allow a trial listening test before securing the loudspeakers into their mounting locations. 7 english CAUTION: Make sure that all speaker wiring is fully protected from cutting or wear. Any short circuits developing as a result could severely damage the radio/cassette unit or amplifier. Make sure that all speaker wires easily reach the speaker terminals with stress on the wire or connectors. Securing the loudspeaker Once you have tested the complete speaker system and have confirmed correct operation, turn the audio system off and prepare the loudspeaker for final mounting. Place the loudspeaker within the mounting ring as shown in the illustration below. Position the loudspeaker assembly into the mounting hole and confirm correct mounting screw hole location. [. . . ] at your expense and risk c) the receipt/invoice as proof of purchase is enclosed 5) Excluded from the warranty are: a) Shipping damages, either readily apparent or concealed (claims for such damages must be immediately notified to the forwarding agent). b) Scratches in metal parts, front panels or covers etc. This must be notified to your dealer within 5 days of purchase. [. . . ]