Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual HELIX SPXL 1000. We hope that this HELIX SPXL 1000 user guide will be useful to you.
Lastmanuals help download the user guide HELIX SPXL 1000.
Detailed instructions for use are in the User's Guide.
[. . . ] For safety reasons, the amplifier must be secured in a professional manner. This is performed by means of four fixing screws screwed into a mounting surface offering sufficient retention and stability. [. . . ] These controls are not volume controls and are solely intended for the purpose of sensitivity trimming. the control range extends from 200 mV to 6 V. 11 Bassboost control To raise the bass signal from 0 to 18 dB at the center frequency being adjusted by control 12. 4 Connecting the ground cable The ground cable should be connected to a central ground reference point (this is located where the negative terminal of the battery is grounded at the metal body of the vehicle), or to a bright bare-metal location on the vehicle chassis, i. An area which has been cleaned of all paint residues. Never connect the loudspeaker cables with the car chassis gound. The impedance per channel should not be lower than 1 ohm as overheating could cause a shut down of the amplifier. 6 Speaker connection for Master and Slave Mode See figures on this page and instructions following No. 12 Control to raise the center frequency This control adjust the frequency from 40 to 120 Hz, which could be raised from 0 - 18 dB by control 11. Signal inputs Signal outputs Level controls for input sensitivity Bass boost control Control to raise the center frequency Frequency control for low pass 7 Protect Bridge To reach maximum power from the Master and Slave Mode during competition (60 to 80 Hz test tone) for a low-ohmic subwoofer combination, the protection circuit can be deactivated by bridging the Protect Bridge contacts. Don't bridge contacts when operated with music signals. 14 Phase control This control enables the phase of the bass signal to be shifted by 180° in order to achieve optimum delay equalization with the other channels. Therefore we grant a warranty period of 2 years. The products checked and tested carefully during the entire production process. [. . . ] In order to operate two amplifiers in this mode, they must be connected with a RCA cable (In/Out). Amplifier1 (Master) takes over the complete control (active crossover, gain etc. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE HELIX SPXL 1000
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual HELIX SPXL 1000 will begin.
