User manual HERKULES AFC2

[. . . ] Read and understand all warnings, cautions and instructions before operating this equipment. It is the owner/operators responsibility to maintain the legibility of all warning and instruction labels. Do not alter or modify any part of this equipment. Do not attempt to bypass the door/latch interlock system. [. . . ] · · · · · Operates with external air only. Safe double lock door protects operator. Removes 95-98% of residual liquid from can. Two can capacity. Page 4 of 8 OWNER/OPERATOR RESPONSIBILITY It is the responsibility of the owner/operator to properly use and maintain this equipment. The instructions and warnings contained in this manual shall be read and understood by the owner/operator prior to operating this equipment. If an owner/operator does not understand English, the contents of this manual shall be explained in the owner/ operator native language to assure the owner/operator comprehends. It is the responsibility of the owner/operator to maintain the legibility of all warning and Instruction labels. The owner/operator shall retain this manual for future reference to Important warnings, operating and maintenance instructions. Fume extractor INSTALLATION Installation consists of anchoring the unit to the floor, connecting an external air supply with 100 to 120 p. s. i. , routing the liquid waste drain to a suitable liquid waste reservoir and connecting a 2" id exhaust Figure 1 hose to the fume extractor. DO NOT attempt to operate the unit while on a skid. The initial crush of the can will cause the unit to move or jump if not secured properly. The crusher must be anchored to the floor before operating. relief valve that will bleed off air if the unit is inadvertently connected to an air source greater than 125 p. s. i. Anchor the unit to the floor using 1/2" diameter hardware. Connect the supplied pressure regulator/filter to the crusher 3/8" NPT air inlet fitting. Connect the external air supply to the pressure regulator/filter. Connect the liquid waste drain line to the crushers 1-1/2' NPT liquid waste drain fitting. Connect 2" ID exhaust hose to fume extractor located on the back of the 1/2" Floor anchor Page 5 of 8 Liquid waste drain fitting 3/8 NPT Air Inlet Filter/Regulator crushing chamber. INSPECTION Prior to operation, a visual Inspection shall be made. Check crusher for leaks, worn or missing parts. Any crusher that appears to be damaged in any way, is badly worn or operates abnormally shall be removed from use until repairs are made. Contact a factory authorized service center for repairs. If over pressurizing of the equipment is believed to have occurred, contact a factory authorized service center for inspection of the crusher. [. . . ] MAINTENANCE Regularly check the pressure filter/regulator moisture trap for water. Regularly check the waste oil drain line system to prevent liquid backing up in the crusher chamber. Regularly clean the crusher chamber to remove any accumulated sludge, metal particles or any other debris that could affect the crusher operation or block the waste drain system. Apply grease to door hinges on a regular basis to prevent the door from binding. [. . . ]