User manual HERKULES G510

[. . . ] Use the equipment only for its intended use. Do not exceed the maximum working pressure of the lowest rated system component. Do not operate the gun washer at a pressure above the maximum working pressure rating of the gun(s) being cleaned. Route the hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. [. . . ] npt male coupler, that is compatible with the quick disconnect of your air supply line, into the air supply port of the filter/regulator located on the back right leg. Connect air line with at least 75 psi to the coupler. Do not adjust. Air supply port 2) Page 5 of 12 Operation Adding water to the Gun Washer 1) 2) Insert the filter mount frame into the bucket. Fill the bucket with water until the water level reaches the bottom of the filter support cross arms. Connect the large filter bag to the filter mount frame so that the bottom of the filter is resting on the filter support. Insert the small filter bag into the large bag and connect to the filter mount frame. Place the bucket under the Gun Washer and insert the pick up tube between the bucket wall and the filter. Close ball valve. Ball valve 3) Pick up tube 4) Filter mount frame 5) 6) Preparing the equipment to be washed 1) Remove paint cup or paint line and the air line from the paint gun. Drain excess paint from cup and gun into a separate container. Remove all gauges and regulators from painting equipment. Remove the air cap/fluid tip from the paint gun. Connect the air channel line to the spray gun using the supplied quick disconnects or replace the supplied quick disconnects with ones compatible with the shops equipment. Cleaning gun Indicator 2) 3) 4) 5) CAUTION Paint channel All pressure gauges must be removed before placing the equipment in the gun washer to avoid damaging the gauges. Cleaning equipment 1) Set the indicator on the front leg to cleaning brush. Press the foot pedal located at the bottom of the front leg to activate the cleaning brush. Manually clean the paint cup (if present), the removed air cap assembly and the outside of the paint gun. Set the indicator on the front leg to pressure clean. Place the nozzle of the cleaning gun into the paint channel of the spray gun. Air channel line Cleaning gun 4) Press on the foot pedal, squeeze the trigger of the spray gun while pressing the trigger of the cleaning gun to send a pressurized flow of water through the paint channel. 2) 3) Note: Position the spray gun so that the flow of water exiting the paint gun is contained within the Gun Washer tub. Page 6 of 12 Operation Clean rinse 1) 2) Fill an additional bucket (not supplied) with clean water. Insert the clean rinse pump inlet tube located on the left side of the Gun Washer in the bucket. Set the rinse / agitator switch on the right side of the Gun Washer to rinse. Place the nozzle of the rinse gun into the paint channel of the paint gun. Squeeze the trigger of the spray gun while pressing the trigger of the rinse gun to send a pressurized flow of clean water through the paint channel. Return the rinse / agitator switch to the neutral position when finished. Use the air gun to dry off any wet components. [. . . ] Make sure the indicator on the front leg is set to pressurized clean. Make sure intake filter is not clogged (Clean or replace). Make sure the air line is properly connected with at least 75 psi. Check all air connections to ensure that there are no leaks. [. . . ]