User manual HERKULES HCR3

[. . . ] 2 3 4 5 6 7 8 9 10 11 Read and understand all warnings, cautions and instructions before operating this equipment. It is the owner/operator's responsibility to maintain the legibility of all warning and instruction labels. Do not alter or modify any part of this equipment. Do not attempt to bypass the door/latch interlock system. [. . . ] If an owner/operator does not understand English, the contents of this manual shall be explained in the owner/ operator native language to assure the owner/operator comprehends. It is the owner/operator's responsibility to maintain the legibility of all warning and Instruction labels. The owner/operator shall retain this manual for future reference to important warnings, operating and maintenance instructions. Page 4 of 8 INSTALLATION See figures 1 & 2. Step 1 Set the unit on a bench or table that can support its weight. It is recommended that the unit be lagged or bolted down. Step 2 Assemble the oiler to the vavle using (1) 1/4 NPT hex nipple. Note: Arrow on oiler must point towards the valve Step 3 Assemble the air pressure gauge to the filter/regulator by first removing the plug on the side with the arrow pointing from left to right. Step 4 Assemble the filter/regulator to the oiler using (1) 1/4 NPT hex nipple. Note: Arrow on filter/regultor must point towards the valve Step 5 Fill the oiler with 30W non-detergent oil Note: Set to about 1/3 of max drip rate. Lower drip rate if cylinder is leaking oil. Step 6 Attach the provided hose barb to the filter/regulator. Step 7 Connect air supply to the hosebarb. Air supply To valve Note: Air supply should not exceed 120 psi. Hose Barb #57 Air Gauge #008-370 Filter/Regulator #T17M Page 5 of 8 Oiler figure 1 Control valve Filter/Regulator Mounting holes Nipple #M25 figure 2 Oiler #T18 INSPECTION Prior to operation a visual Inspection shall be made. Check crusher for leaks, worn or missing parts. Any crusher that appears to be damaged in any way, is badly worn or operates abnormally shall be removed from use until repairs are made. Contact a factory authorized service center for repairs. If over pressurizing of the equipment is believed to have occurred, contact a factory authorized service center for inspection of the crusher. An annual inspection by a factory authorized service center is recommended. OPERATION 1) 2) Turn the external air supply on. [. . . ] Adequate personal protection is recommended to prevent splashing of fluids on the skin or in the eyes. MAINTENANCE Regularly check the pressure filter/regulator moisture trap for water. Fill to 3/4 full with 30W non-detergent oil when necessary. Regularly clean the crusher chamber to remove any accumulated sludge, metal particles or any other debris that could affect the crusher operation. [. . . ]