User manual HERKULES OFC1

[. . . ] 2 3 4 5 6 7 8 9 10 11 Read and understand all warnings, cautions and instructions before operating this equipment. It is the owner/operators responsibility to maintain the legibility of all warning and instruction labels. Do not alter or modify any part of this equipment. Do not attempt to bypass the door/latch interlock system. [. . . ] If an owner/operator does not understand English, the contents of this manual shall be explained in the owner/ operator native language to assure the owner/operator comprehends. It is the responsibility of the owner/operator to maintain the legibility of all warning and Instruction labels. The owner/operator shall retain this manual for future reference to important warnings, operating and maintenance instructions. INSTALLATION 1 2 Bolt stabilizer feet to the bottom of the stand with the 3/8-16 X 3/4" bolts. Bolt cabinet to stand with the 3/8-16 X 2-1/2" bolts, nuts and washers provided. Assemble the Filter/Regulator assembly using a thread sealer. Note: Make sure that the arrows are pointing toward the unit (see fig 1). 1 3 Filter/Regulator 3/8 NPT Air Inlet Oiler 4 Fill the oiler with 30W non-detergent oil before attaching airline. NEVER REMOVE OILER WITH AIR ATTACHED Route your airline safely to prevent tripping and possible tipping the machine over. Use an unrestricted airline (no quick connects) at 100-120 psi and 3/8" to 1/2" ID. Attach the 3/4" nipple to the bottom of the unit and select a waste oil container to put under the unit. A hose may be run from the outlet to a remote container. Turn on air and set regulator to 100-120 psi. Page 5 of 8 5 6 7 INSPECTION Prior to operation a visual Inspection shall be made. Check crusher for leaks, worn or missing parts. Any crusher that appears to be damaged in any way, is badly worn or operates abnormally shall be removed from use until repairs are made. Contact a factory authorized service center for repairs. If over pressurizing of the equipment is believed to have occurred, contact a factory authorized service center for inspection of the crusher. An annual inspection by a factory authorized service center is recommended. OPERATION 1 2 Turn the external air supply on. Verify the pressure gauge on the pressure regulator/filter reads between 100 and 120 p. s. i. NOTE: If the external air supply is less than 100 p. s. i. , the crusher will operate but the crushing performance is reduced. [. . . ] Dangerous shrapnel explosions could happen. Place only one filter in chamber, vertically only, open side down. Never place more than one filter in the crushing chamber at any time. Operate only with slip-in tray in place. MAINTENANCE · · · · · Check oiler level weekly to keep adequate oil in the air cylinder. [. . . ]