User manual HERKULES OFC3

[. . . ] 2 3 4 5 6 7 8 9 10 11 Read and understand all warnings, cautions and instructions before operating this equipment. It is the owner/operators responsibility to maintain the legibility of all warning and instruction labels. Do not alter or modify any part of this equipment. Do not attempt to bypass the door/latch interlock system. [. . . ] · · · · · Operates with external air only. Safe double lock door protects operator. Removes 95-98% of residual oil from oil filter. Four oil filter capacity. Page 4 of 8 OWNER/OPERATOR RESPONSIBILITY It is the responsibility of the owner/operator to properly use and maintain this equipment. The instructions and warnings contained in this manual shall be read and understood by the owner/operator prior to operating this equipment. If an owner/operator does not understand English, the contents of this manual shall be explained in the owner/ operator native language to assure the owner/operator comprehends. It is the responsibility of the owner/operator to maintain the legibility of all warning and Instruction labels. The owner/operator shall retain this manual for future reference to Important warnings, operating and maintenance instructions. INSTALLATION Installation consists of anchoring the unit to the floor, connecting an external air supply with 100 to 120 p. s. i. and routing the waste oil drain to a suitable waste oil reservoir. DO NOT attempt to operate the unit while Figure 1 on a skid. The initial crush of the oil filter(s) will cause the unit to move or jump if not secured properly. relief valve that will bleed off air if the unit is inadvertently connected to an air source greater than 125 p. s. i. Anchor the unit to the floor using 1/2" diameter hardware. Connect the supplied pressure regulator/filter to the crusher 3/8" NPT air inlet fitting. Connect the external air supply to the pressure regulator/filter. Connect the waste oil drain line to the crusher 1-1/2' NPT waste oil drain fitting. 1/2" Floor Anchor 3/8 NPT Air Inlet Waste oil drain fitting Filter/Regulator Page 5 of 8 INSPECTION Prior to operation a visual Inspection shall be made. Check crusher for leaks, worn or missing parts. Any crusher that appears to be damaged in any way, is badly worn or operates abnormally shall be removed from use until repairs are made. Contact a factory authorized service center for repairs. If over pressurizing of the equipment is believed to have occurred, contact a factory authorized service center for inspection of the crusher. An annual inspection by a factory authorized service center is recommended. [. . . ] MAINTENANCE Regularly check the pressure filter/regulator moisture trap for water. Regularly check the waste oil drain line system to prevent oil backing up in the crusher chamber. Regularly clean the crusher chamber to remove any accumulated oil sludge, metal particles or any other debris that could affect the crusher operation or block the waste oil drain system. Apply grease to door hinges on a regular basis to prevent the door from binding. [. . . ]