User manual HILTI DCM 2

[. . . ] Don't unplug the charger by pulling on the supply cord. Don't expose t^ l 1. 4uo;X short circuits. Short circuiting the contacts of the charger or battery oresents a risk of fire. lZ\ the supply cord to heat, oil or sharp edges. lf the supply cord becomes damaged while working, don't touch it - unplug the mains plug immediately. 6. . N lzf Keeplhe chargerand batteriesin good con- dition. Follow the instructions on care and maintenance. [. . . ] Never 0perate the charger when it is dirty or wet. Under unfavourable conditions, dampness or dirt adherlng to the surface of the charger may present a risk of electric sh ock. 2. Take the inlluences ol lhe surrounding area into account. Don't expose the charger to rain and don't use it in damp 0r wet surroundings or in the vicinity of flammable liquids or gases. g. cneck the charger each time belore use. Checkthe condition ofthe charger, supply cord and plug. Don't use the charger if it is found to be damaged, incomplete or if the controls cannot be operated c0rrectly. lZ\ , \- Repairs t0 the charger including, in pafiicular, replacement of the supply cord, may be canied out only by the manufacturer or authorised service centre using original Hilti spare parts. Failure to observe this point may result in damage 0r present a risk of accident. Accordingly, if necessary, have the charger repaired at a Hilti service centre or authorised Hilti repair workshop. 4. Use the chalger only lor the puryose for which it is intended. Before use f Condilioning charge mode E Z\1 lt is essential that the safety precautions printed in these operating instructions are read and observed. Ll\l f l ^ lf ^ l /\ - Connect the charger to the mains supply. The mains voltage must corresp0nd to the information given on the rating plate. NiCd cells are subject to self-discharge. exposed to the sun, at a window, behind a car windscreen or on a radiator). ^ /\ l AThe Green -At charger is designed for use with the batteries listed above. lt must not be used to charge other batteries. Indicators Zl Lights when the charger is connected to the mains supply Blinks when the self-test determines a LED - Red LED fault in the charger or battery - Lights when the battery is being charged (charging in progress) Blinks when the battery is charged Never fully discharge a battery. Change the battery as s00n as its 0erformance droos. The cells that reach a state of total discharge first will otherwise be damaged by the current still being drawn from the other cells. An excepti0n to this is the BP 6-86 battery for the TE 6-4 (this battery is equipped with an electronic deep discharge prevention device). (workinq capacitv reached) Blinks when the battery is too cold (approx. Yellow LED - 0'C) or too hot (approx. The charger begins charging automatically as soon as the battery reaches the required remperaru re. - Lights when the charger is operating in conditioning charge mode. Care and maintenance Care of the charger The outer casing of the charger is made f Warranty rom impactHilti warrants that the tool supplied is free of defects in material and workmanship. This warranty is valid so long as the tool is operated and handled correctly, cleaned and serviced properly and in accordance with the Hilti 0perating Instructions, all warranty claims are made within 12 months from the date of the sale (invoice date), and the technical system is maintained. This means that only original Hilti consumables, c0mponents and spare parts may be used in the tool. This warranty provides the free-of-charge repair or replacement of defective parts only. [. . . ] This means that only original Hilti consumables, c0mponents and spare parts may be used in the tool. This warranty provides the free-of-charge repair or replacement of defective parts only. Parts requiring repair or replacement as a result of normal wear and tear are not covered bv this warranry. resistant plastic. Clean the outside of the charger at regular intervals using a slightly damp cloth. Do not use a spray, tat tAl |lAl @l steam pressure cleaning equipment or running water for cleaning. [. . . ]