User manual HILTI DX 600N

[. . . ] E:- 3/T69 wire brush 4553840 _l-*- Tool parts DX400B 123456 (ox4oo E conversion parts shown above) t-Qm 1 2 rE r, . ;''li -li_ 9 lM;\l, i /i, i'i', i'lV 10 1t 12 3 4 5 6 7 9 10 11 12 13 B baseplate front guide stop ring stop pressure piston chamber firing pin return firing firing pin firing pin end 4BlF1 0402101 cap 0402931 o4o2941 sleeve holder 0402986 ring 0451655 spring O4O2937 bushing 0402913 spring o4o292g pin 0402924 guide 0402926 spring 0402930 O4O2922 cap Catalog No. $ N, , VVJ. . ll o r t-r 13 ll 8 ll -l -ri Operating precautions 1. Never load the tool until you are ready to use d. [. . . ] Never cock the toolagainst the hand or point the tool at anyone. lf a booster tails to igniie: a) Keep the lool pressed against the work surface for thirty (30) seconds. b) lf the boosterdoes not ignile, withdraw the tool approximately 2" from the work surface (to recock the tiring mechanism), taking care thal it never points at yourself or anyone else. c) Beposition the tool against the work surface, fully depress the guide, and again squeeze the trigger. d) lf the boosler still fails to ignite, wait another thirty (30) seconds, carefully remove the toolfrom the work surface, pull oui the baseplate untilthe top of the booster magazine protrudes from the top of the tool. e) Remove the entire booster magazine from the tooland carefully dispose of it by placing il in a container of water or oil. Do not aitempt to use other boosters on the maga- ztne. Minimum iastener spacing in concrete is 2%". Minimum fastener spacing in steel is 1". 9. l\rinimum thickness of base steel is %i'. Warranty I his new fasrenrng lool is a quality product of Hihi. lt has been developed through study and research into construction fastening methods and applications. Every reasonable precaution has been taken in the manufaciure of the tool to assure that it complies with Hilti's standard of high quality. The Hilli tool is warranted lor 5 years to the original purchaser from the date of shipment. The warranty is against defects in material or workmanship, provided that the system is used in accordance with Hilli instructions; repairs have not been made by persons olher than authorized Hilti service personnel; damage is not due to normal wear and tear; the tool has not been abused or misused: and lhe defective iool is returned to the local Hilti representative for forwarding to the Hilti Repair Center. [. . . ] The Hilli tool is warranted lor 5 years to the original purchaser from the date of shipment. The warranty is against defects in material or workmanship, provided that the system is used in accordance with Hilli instructions; repairs have not been made by persons olher than authorized Hilti service personnel; damage is not due to normal wear and tear; the tool has not been abused or misused: and lhe defective iool is returned to the local Hilti representative for forwarding to the Hilti Repair Center. [. . . ]