User manual HILTI GP22

[. . . ] Release the locking sleeve and turn the drill bit until the locking sleeve snaps back into its original position. 5. I;:i;l:, i:ii For rotary drilling: of theChuck: Always clean and lubricate the chuck end of the bit shank before inserting in the drill. To lubricate, spray lightly with Hilti spray lubricant. 2. Lubrication With the drill stopped, pull back the adjusting sleeve all the way and lock by twisting a quarter turn counter clockwise. Place the drill against the work surface, apply light pressure, switch the drill on. [. . . ] Use the center set of marks for a 25:1 ratio. TE-C-BF Keyless Chuck Assembly CAUTION: Never run engine without the air filter installed. SPARK PLUG Check spark plug gap 0. 6-0. 7 mm (D24-. 027 in). To clean spark plug electrode use sandpaper or wire brush. FUEL FILTER No maintenance required. required to correct defects in materials and workmanship provided the tool is returned to Hilti for servicing and inspection, the serial number has not been removed or defaced, only Hilti compatible bits and Hilti parts have been used with the tool, and no unauthorized servicing has been performed. The wananty does not cover normal wear and tear and the cost of shipping and insurance. This is the only warranty or guarantee made by Hilti and it is given in lieu of all other warranties. including implied warranties of merchantability and of fitness for a particular purpose. Under no circumstances will Hilti be obli. gated for damages, losses or expenses in connection with or by reason of , the use of, or inability to use the tool for any purpose. GEAROIL The GP22 is permanently lubricated. No maintenance reouired. For use with smooth shank, high speed steel twist bits up to 112, diameter and wood bits. Do not use in hammer mode. HILTI P. O. OK 74121 (91 8) 252-6000 HILTI is a registered tradem. . rHlLTl Corp. @Copyright 1986 by HlLTl, Inc. Hilti is an equal opportunity company Safety Instructions changing accessories. Inspect tool I READ ALL INSTRUCTIONS 1. Keep Work Area Clean Cluttered areas and benches invite injuries. Keep Children Away Do not let visitors contact tool. All visitors should be kept away from worK area. cords periodically and if damaged have repaired by authorized service facility. Keep handles dry, clean, and free from oil and grease. Remove Adiusting Keys and Wrenches Form habit of checking to see that keys and adjusting wrenches are removed from tool before turnino it on. 3. Store ldle Tools 12. Do not ooerate tool when you are tired. When not in use, tools should be stored in dry, and high or locked-up olace out of reach of children. Don't Force Tool It will do the job better and safer at the rate for which it was intended. [. . . ] Do not allow dust, dirt, fuel, or debris to build up on engine. Before starting make sure that engine has dried completely and that no fuel leaks exist. Do not smoke while fueling or operating the GP22. Do not use tool indoors or in poorly ventilated areas. [. . . ]