User manual HILTI GX120-ME

[. . . ] GX120-ME Hilti Corporation LI-9494 Schaan Tel. : +423 / 234 21 11 Fax: +423 / 234 29 65 www. hilti. com Operating instructions Mode d'emploi Manual de instrucciones Istruzioni d'uso Brugsanvisning Bruksanvisning Bruksanvisning Käyttöohje Manual de instruções Kasutusjuhend en fr es it da no sv fi pt el et zh Hilti = registered trademark of Hilti Corp. , Schaan W 3410 0507 2-Pos. 1 1 Printed in Liechtenstein © 2007 Right of technical and programme changes reserved S. & O. 39199 / A 39199 *39199* 1 5 2 +Ç 1 8 9 +" + +# 7 3 +± +[ 6 Gas 4 5 2 3 1 3 2 1 3 2 4 5 1 2 4 +[ 3 GAS 6 7 6 4 5 2 3 8 9 1 1 1 3 2 2 10 11 + 12 13 1 1 2 2 1 3 14 15 1 3 2 +" 16 17 GX 120ME gas-driven fastening tool It is essential that the operating instructions are read before the tool is operated for the first time. Always keep these operating instructions together with the tool. [. . . ] The operator and bystanders must wear ear protectors. WARNING Never make the tool ready to fire by pressing it against a part of the body (e. g. When the tool is ready to fire, fasteners could be driven inadvertently into parts of the body. Never press the tool against parts of the body. WARNING Never pull the tool nosepiece back by the fastening component inserted in it (e. g. This presents an increased risk of accident. 7 5. Pivot the magazine forward away from the tool. NOTE The locking lever must be in the open position. Guide the magazine toward the tool until the shaped parts fit together. Close the locking lever and check that it engages. 7. 4 Nosepiece 7. 4. 1 Removing the nosepiece 9 1. Set the power regulator to "Eject". 7. 4. 2 Settings at the nosepiece NOTE When the power regulator is set to "+", the nosepiece is set to the standard fastener driving depth. NOTE When the power regulator is set to "", the nosepiece is set to the reduced fastener driving depth. NOTE If the nail is still driven too deeply when the power regulator is set to "", it may be necessary to use a longer nail. 7. 4. 2. 1 Setting the standard fastener driving depth 10 Set the power regulator to "+". 7. 4. 2. 2 Setting the reduced fastener driving depth 10 NOTE This setting is suitable for fastening thin sheet metal to soft materials (e. g. Set the power regulator to "". 7. 4. 3 Fitting the tool nosepiece 11 WARNING Check to ensure that the tool is not loaded. The tool could be made ready to fire inadvertently by pressing the nosepiece in by hand. 1. Align the nosepiece with the slot in the tool. While holding the nosepiece with the hand, press the tool against the working surface until the nosepiece engages in position. [. . . ] Take care to ensure that the tool is lifted away completely from the working surface after driving each fastener. Remove the tool nosepiece from the tool. Fit the tool nosepiece into the support supplied and use the pin punch to remove the fastener. CAUTION Do not damage the tool nosepiece. [. . . ]