User manual HILTI HIT-MD2000

[. . . ] Ensure that the operating instructions are with the tool when it is given to other persons. Operating controls and parts Mixing nozzle for use with Hilti HIT adhesive mortar (see applicable operating instructions) Hilti HIT foil pack (inserted) Foil pack holder Impact-resistant, metal-reinforced plastic cradle for the holder Switch for selecting neutral position, single-stroke or continuous operating mode Parallel piston rods with plastic grip for retracting the rods Release button Opening to facilitate removal of the foil pack holder Trigger for controlling injection of the adhesive mortar Battery Mains adaptor Release buttons for detaching the battery / mains adaptor (both sides) 1. General information 1. 1 Safety notices and their meaning -WARNINGDraws attention to a potentially dangerous situation that could lead to serious personal injury or fatality. -CAUTIONDraws attention to a potentially dangerous situation that could lead to slight personal injury or damage to the equipment or other property. -NOTEDraws attention to instructions and other useful information. [. . . ] If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns. 5. 1. 6 Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. 5. 2 Additional safety precautions 5. 2. 1 Electrical safety the extension cord and replace it if damage is found. Do not touch the supply in the event of it suffering damage while working. Disconnect the supply cord plug from the socket. Damaged supply cords and extension cords present a risk of electric shock. c) Do not insert the mains adaptor into the battery charger, especially when the mains adaptor supply cord is plugged into the electric supply. 5. 2. 2 Work area a) Ensure that the workplace is well lit. b) Ensure that the workplace is well ventilated. Batteries should be stored at room temperature. Never store the battery where it is exposed to direct sunlight or sources of heat, e. g. on heaters / radiators or behind a motor vehicle windscreen. Batteries that have reached the end of their life must be disposed of safely and correctly to avoid environmental pollution. To achieve optimum results, it is recommended that the dispenser, battery and foil packs are at room temperature before use. The foil packs and battery should always be kept warm when working outdoors in low temperatures. 6. 2 Charging the battery en -CAUTIONUse only Hilti SFB 121 or SFB 126 batteries. Check the expiry date (month / year) and observe the product designation printed on the front of the foil pack junction piece. If it is found necessary to make a complaint, please quote the lot number. Insert the foil pack into the holder as far as it will go and then screw on the mixing nozzle. The temperature of the foil pack before use must be no less than the minimum temperature given in the corresponding instructions for use of the adhesive mortar. [. . . ] Switch the tool off immediately, remove the battery / mains adaptor and contact Hilti Service. Use the right tool for the job (don't use a low-powered tool for heavy work). 17 The tool has been overloaded (application limits exceeded). Disposal -CAUTIONImproper disposal of the equipment may have serious consequences: The burning of plastic components generates toxic fumes which may present a health hazard. [. . . ]