Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual HILTI HIT-P 8000D. We hope that this HILTI HIT-P 8000D user guide will be useful to you.
Lastmanuals help download the user guide HILTI HIT-P 8000D.
Detailed instructions for use are in the User's Guide.
[. . . ] For diamond cored boreholes and if a dry borehole is required for injection (e. g. water flows into cleaned borehole), continue with borehole cleaning as described by methode 1. Remove all standing water completely (i. e. vacuum, compressed air or other appropriate procedure). [. . . ] The borehole must be free of dust, debris, ice, oil, grease and other contaminants prior to adhesive injection. Inadequate borehole cleaning = poor load values 5. Never use damaged foil packs and/or damaged or unclean foil pack holders. Tightly attach Hilti HIT-RE-M mixer to foil pack manifold. Attach new mixer prior to dispensing a new foil pack (snug fit). Make sure the mixing element is in the mixer. Use only the mixer supplied with the adhesive. Insert foil pack holder with foil pack into HIT-dispenser. Push release trigger, retract plunger and insert foil pack holder into the appropriate Hilti dispenser. The foil pack opens automatically as dispensing is initiated. Depending on the size of the foil pack an initial amount of adhesive has to be discarded. Mark and set anchor/rebar to the required embedment depth. Before use, verify that the anchor/rebar is dry and free of oil and other contaminants. To ease installation, anchor/rebar may be slowly twisted as they are inserted. After installing an anchor/rebar, the annular gap must be completely filled with adhesive. If the borehole is not completely filled along the embedment depth the installation should be rejected. Hilti should be contacted for further information. For overhead applications take special care when inserting the anchor/rebar. Excess adhesive will be forced out of the borehole -- take appropriate steps to prevent it from falling onto the installer. Position the anchor/rebar and secure it from moving/falling during the curing time (e. g. Observe the gel time "t gel", which varies according to temperature of base material. Minor adjustments to the anchor/rebar position may be performed during the gel time. [. . . ] Minor adjustments to the anchor/rebar position may be performed during the gel time. Do not disturb the anchor/rebar once the gel time "t gel" has elapsed until "t cure, ini" has passed. Preparation work may continue for rebar applications. Between "t cure, ini" and "t cure, full" the adhesive has a limited load bearing capacity, do not apply a torque or load on the anchor/rebar during this time. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE HILTI HIT-P 8000D
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual HILTI HIT-P 8000D will begin.
