User manual HILTI PA350

[. . . ] PR 60 / PA 350 GB Operating instructions F Mode d'emploi 1­ 50 51­100 *338416* 338416 Operating Instructions PR 60 / PA 350 PR 60 rotating laser / PA 350 detector Symbols used The symbols used in these operating instructions have the following meanings: WARNING Usage risk or incorrect use which could lead to severe personal injury of a fatal accident. CAUTION Usage risk or incorrect use which could lead to only minor personal injury but considerable damage to property or the environment. Usage information which helps the user to employ the instrument efficiently and in a technically correct manner. Besides the instructions for use, these operating instructions also contain important safety information (see "Safety instructions" section). Please read these operating instructions carefully before operating the tool for the first time. [. . . ] Operation and use Inserting the batteries (PR 60) 1 LED blinks: Replace the batteries The LEDs blink alternately as long as some voltage is present: Batteries are discharged; the unit cannot be operated. Inserting new batteries 4 A 1 2 5 6 3 1 Turn lever A from LOCK to OPEN. 2 Pull the battery holder out of the tool. 3 Remove the old batteries and dispose of them in accordance with regulations. 4 Insert new batteries, taking care to observe correct polarity. 5 Push the battery holder into the tool. Operation and use Inserting the batteries (PR 60) The «low batteries» warning is detected by the PA 350 and indicated: The symbol then blinks. To deactivate the warning on the PA 350: Press and hold the "Buzzer" on. button an then press the «ON» button to switch Inserting the batteries (PA 350) The following symbols indicate the condition of the battery in the PA 350: Battery voltage is adequate. The tool will, nevertheless, continue to function (symbol alternates between charged and discharged). To replace / insert a new battery, open the battery compartment. Remove the used battery and dispose of it in accordance with regulations. Insert the supplied 9 V block battery (or a new battery) and then push the battery holder back into the tool. Always replace the complete set of batteries!- Do not use batteries of different makes or of different types. Operation and use Setting up and operating the tool 1. PA 910) on a steady, approximately horizontal surface. Take care to ensure that as many measuring points as possible can be reached. Open the quick-release clamps on the tripod legs, pull the legs out to the required height and then close the clamps. Press the points of the tripod legs into the ground by applying foot pressure, thus ensuring that the tripod stands securely. When applying foot pressure to the tripod legs, ensure that the force applied acts towards the point of the leg. 31 3. Operation and use Setting up and operating the tool, continued When setting up the tripod, take care to ensure that the tripod top plate is approximately horizontal. [. . . ] FCC statement (applicable in U. S. ) 6. FCC statement (applicable in U. S. ) WARNING This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ]