User manual HILTI PD-30

[. . . ] PD 30 en Operating instructions *372204* 000000 5 2 9 10 9 7 10 4 8 6 31 PDA 50 PDA 80 PDA 60 PDA 81 PDA 61 PDAW 80-1 PDA 62 PDAW 80 / 81-1 PDA 70 PDAW 80 / 81-2 PA 970 PDAW 80 / 81-3 PDAW 81-1 PD 30 laser range meter It is essential that the operating instructions are read before the range meter is used the first time. Always keep these operating instructions together with the tool. Ensure that the operating instructions are with the range meter when it is given to other persons. Contents Contents 1. 3 Safety notices and their meaning 3 Pictograms . [. . . ] If it is used frequently, a shorter battery life must be expected. 7. 3 Measuring distances Distance measurements can be taken to all "non-cooperating" stationary targets, i. e. concrete, rock, wood, plastic, paper, etc. , The use of prisms or other strongly reflecting targets is not permitted and, if used, might falsify the results. 7. 3. 1 Measuring references = switch key The range meter can measure distances from three different measuring reference points. By pressing the "switch" key on the left at the front of the range meter the measuring reference point toggles between front edge and rear edge. If the spike is folded out 90°, the reference position is set to the end of the spike. Display Reference position Front edge Rear edge End of spike 15 - NOTE ­ If the spike is folded out 180°, reference point is always automatically set to the rear edge. 7. 3. 2 Measuring distances step by step The range meter measures distances in a very short time and, when doing so, shows various information in the display. Switch on the range meter by pressing the "On" key. 2. This switches on the red laser beam which is visible as a laser spot on the target surface. The display shows this aiming mode as an animated dashed line 3. Press the "Measure" key once again to measure the distance. 7. Operation The result appears in the result line normally in less than a second. 7. 3. 3. 1 Single distance measurement ("Measure" key) 1. Switch on the laser beam by pressing the "Measure" key. Press the "Measure" key once again. Generally, the measured distance will be completed in less than a second and shown in the result line the display. - NOTE Alternatively the range meter may be switched on by pressing the On key and the laser then activated by pressing the measure key. 7. 3. 3. 2 Continuous measurement Press the "Measure" key for about 2 seconds to activate this measuring mode. When doing so, it does not matter whether or not the range meter is off or the laser beam is switched on or off. The range meter will always switch to continuous measurement. During continuous measurement, the distances are updated in the result line by about 8 to 15 measurements every second. [. . . ] Separate the individual parts as follows: Part / assembly Casing Main material Plastic Recycling as Plastic / scrap metal Plastic scrap metal Electronics scrap * Plastic scrap Switch Plastic Screws / small parts Steel, aluminium, magnets Electronics Various (Re-chargeable) Alkali manganes batteries, carrying case* woven synthetic fabric - NOTE Always remove the batteries before shipment. 24 * Dispose of batteries in accordance with national regulations 12. Warranty / 13 FCC statement (applicable in US) 12. Warranty Hilti warrants that the product supplied is free of defects in material and workmanship. This warranty is valid as long as the product is operated and handled correctly, cleaned and serviced properly and in accordance with the Hilti operating instructions, all warranty claims are made within 12 months from the date of the sale (invoice date), and the technical system is maintained. [. . . ]