User manual HILTI PMC 46

[. . . ] It is essential that the operating instructions are read before the tool is operated for the first time. Always keep these operating instructions together with the tool. Ensure that the operating instructions are with the tool when it is given to other persons. The illustrations can be found on the fold-out cover pages. [. . . ] Do not discharge the batteries by short circuiting as this may cause them to overheat and present a risk of personal injury (burns). Do not attempt to open the batteries and do not subject them to excessive mechanical stress. Do not mix batteries of different makes or types. B) To avoid pollution of the environment, the tool must be disposed of in accordance with the cur- 6 Liquids Under abusive conditions, liquid may leak from the battery. In the event of the liquid coming into contact with the eyes, rinse the eyes with plenty of water and consult a doctor. Liquid ejected from the battery may cause irritation or burns. Remove the batteries from the packaging and insert them in the tool. NOTE Only batteries recommended by Hilti may be used to power the tool. 2 Switching the tool / laser beams off Press and hold the on-button until the laser beam is no longer visible and the LED no longer lights. NOTE The tool switches itself off automatically after approx. Until the laser beam blinks three times as confirmation. NOTE The tool will be switched off when the on-button is pressed or when the batteries are exhausted. The tool does not level itself automatically. 5 Using the tool with the PMA 31 laser receiver For further information, please refer to the PMA 31 operating instructions. 2 Setting out drywall track for a partition wall 4 7. 6 Marking out the position of light fittings 8 7. Make a mark on the floor (a cross) in a high room (e. Position the tool with the lower beam on the center of the cross. Attach a piece of paper to the ceiling before making the mark. NOTE The lower plumb beam must remain on the center of the cross. Repeat the procedure after pivoting the tool through 180° and 270°. NOTE The resulting 4 marks form a circle in which the intersection of the diagonals d1 (1 ­ 3) and d2 (2 ­ 4) marks the exact center of the plumb point. [. . . ] In many countries, Hilti has already made arrangements for taking back old tools or appliances for recycling. Ask Hilti Customer Service or your Hilti representative for further information. For EC countries only Disposal of electric appliances together with household waste is not permissible. In observance of European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in accordance with national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. [. . . ]