User manual HILTI PMC36

[. . . ] Keep these pages open while studying the operating instructions. In these operating instructions, the designation "the tool" always refers to the PMC36 combilaser. Parts, operating controls and indicators 1 @ On-button ; LED = Pendulum % Removable foot & Back of the tool 1 Safety notices and their meaning DANGER Draws attention to imminent danger that could lead to serious bodily injury or fatality. WARNING Draws attention to a potentially dangerous situation that could lead to serious personal injury or fatality. [. . . ] I) Do not use the tool in the proximity of medical instruments. 3 Electromagnetic compatibility Although the tool complies with the strict requirements of the applicable directives, Hilti cannot entirely rule out the possibility of the tool being subject to interference caused by powerful electromagnetic radiation, leading to incorrect operation. Check the accuracy of the tool by taking measurements by other means when working under such conditions or if you are unsure. Likewise, Hilti cannot rule out the possibility of interference with other devices (e. 4 Laser classification for laser class 2 / class II appliances Depending on the version purchased, the tool complies with Laser Class 2 in accordance with IEC8253:2007 / EN60825-3:2007 and Class II in accordance with CFR 21 § 1040 (FDA). This tool may be used without need for further protective measures. The eyelid closure reflex protects the eyes when a person looks into the beam unintentionally for a brief moment. This eyelid closure reflex, however, may be negatively affected by medicines, alcohol or drugs. Nevertheless, as with the sun, one should not look directly into sources of bright light. Consult the manufacturer if you are unsure of how to proceed. Keep the batteries out of reach of children. NOTE The lower plumb beam must remain on the center of the cross. Repeat the procedure after pivoting the tool through 180° and 270°. NOTE The resulting 4 marks form a circle in which the intersection of the diagonals d1 (1 ­ 3) and d2 (2 ­ 4) marks the exact center of the plumb point. The result (R) provided by this formula (RH = room height) refers to the tool's accuracy "in mm at 10 m" (formula (1)). This result (R) should be within the specification for the tool (3 mm at 10 m). 20 cm from the wall (A) with the laser beam directed toward the wall (A). Mark the point of intersection of the laser lines on the wall (A) with a cross. Pivot the tool through 180° and mark the point of intersection of the laser lines on the opposite wall (B) with a cross. 20 cm from the wall (B) with the laser beam directed toward the wall (B). Mark the point of intersection of the laser lines on the wall (B) with a cross. Pivot the tool through 180° and mark the point of intersection of the laser lines on the opposite wall (A) with a cross. [. . . ] Careless disposal may permit unauthorized and improper use of the equipment. This may result in serious personal injury, injury to third parties and pollution of the environment. Most of the materials from which Hilti tools or appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. [. . . ]