User manual HILTI PML32

[. . . ] 8 PML 32 / PML 32-R Hilti Corporation LI-9494 Schaan Tel. : +423 / 234 21 11 Fax: +423 / 234 29 65 www. hilti. com Bedienungsanleitung Operating instructions Mode d'emploi Istruzioni d'uso Manual de instrucciones Gebruiksaanwijzing de en fr it es nl 9 Hilti = registered trademark of Hilti Corp. , Schaan W 2765 0906 00-Pos. 1 1 Printed in Liechtenstein © 2006 Right of technical and programme changes reserved S. & O. 377394 / E 377394 *377394* 1 2 6 3 4 5 7 It is essential that the operating instructions are read before the tool is operated for the first time. Always keep these operating instructions together with the tool. [. . . ] Safety precautions ­ Although the tool is protected to prevent entry of dampness, it should be wiped dry each time before being put away in its transport container. 5. 4. 1 Electrical hazards ­ The batteries must be insulated or removed from the tool before it is shipped. ­ The tool and the batteries must be disposed of in accordance with national regulations in order to avoid environmental pollution. Consult the manufacturer if you are unsure. 13 6. Operation 6. 1 Inserting new batteries -NOTEDo not use damaged batteries. Do not mix batteries of different makes or types. Bring the two parts of the tool into the closed position. Press the battery compartment release button. Pull the battery holder downwards out of the tool. -CAUTIONTake care to observe correct polarity when inserting the batteries. Check that it engages securely. 14 7. Operation -NOTEThe pendulum is locked when the tool is in the closed position (laser beam blinks). 7. 1 Operation 7. 1. 1 Bringing the tool into the operating position 1. Open the tool to the 90° or 180° position. Bring the reference line into alignment with (parallel to) the top edge of the base section. -NOTEThe pendulum is able to swing freely when the reference line is parallel to the base section, when the pendulum lockbutton is not pressed in and when the tool is set up in a horizontal position ( ± 5°). The laser beam blinks rapidly when the tool is unable to level itself automatically. 7. 1. 2 Switching on the laser beam To switch on only the horizontal beam: 1. Press the selector button once. 15 7. Operation To switch on only the vertical beam: 1. To switch on the horizontal and vertical beams: 1. Press the pendulum lockbutton (the pendulum is then locked). [. . . ] Manufacturer's warranty ­ tools 12. Manufacturer's warranty ­ tools Hilti warrants that the tool supplied is free of defects in material and workmanship. This warranty is valid so long as the tool is operated and handled correctly, cleaned and serviced properly and in accordance with the Hilti Operating Instructions, and the technical system is maintained. This means that only original Hilti consumables, components and spare parts may be used in the tool. [. . . ]