User manual HILTI PP10

[. . . ] 00_Cover_PP_10_11_P2. qxd 23. 1. 2006 09:14 Seite 1 10 11 Hilti Corporation LI-9494 Schaan Tel. : +423 / 234 21 11 Fax: +423 / 234 29 65 www. hilti. com PP 10/11 Operating instructions Bruksanvisning Brugsanvisning en sv da 12 Hilti = registered trademark of Hilti Corp. , Schaan W 3117 0106 00-Pos. 2 Right of technical and programme changes reserved S. & O. 1 Printed in Liechtenstein © 2006 233821 / A 233821 *233821* 00_Cover_PP_10_11_P2. qxd 23. 1. 2006 09:14 Seite 5 1 2 3 6 7 4 5 8 9 PP 10 / 11 pipe laser It is essential that the operating instructions are read before the tool is operated for the first time. Always keep these operating instructions together with the tool. [. . . ] The set value is displayed and the ± indicator blinks. Press the laser beam UP or DOWN button to change the sign. Press the right-hand direction control button in order to reach the correct position (the left direction control button can be used to move back). Press the laser beam UP or DOWN button to change the value. Press the right-hand direction control button to move to the next position. Press the laser beam UP or DOWN button to change the value. Repeat the steps described above to change other numerical values. Press the SET button when the value entered is correct. The laser beam then begins to move to the specified setting. 7. 5. 2 Manual entry of inclination NOTE Inclination can also be set directly by moving the laser beam. Check that the locking function has not been activated. The value indicated becomes higher or lower as the laser beam is moved. Press the laser beam UP and DOWN buttons at the same time to move the laser beam to the zero position. The laser beam moves immediately to the 0. 000% position. 7. 6 Aligning the target line 6 Use the direction control buttons on the PP 10 / 11 or PPA 20 remote control unit to move the laser beam horizontally to the right or left. 8 7. 7 Beam position indicator 6 1 2 3 Beam position indicator End position left End position right en 7. 8 Adjusting the position of the beam 6 The maximum lateral adjustment range is 9m at a distance of 30m. If the button is pressed briefly, the laser beam moves slowly. If the button is pressed for longer, the laser beam moves quickly. The current position of the beam can be read from the display at any time. 7. 8. 1 Adjusting the beam end position left / right The display informs the operator when the beam has reached the left or right end position and cannot be moved further. The display blinks to inform the operator of this status. If this position is reached frequently it is recommended that the tool is pivoted slightly to the left or right and the beam then realigned. [. . . ] This warranty provides the free-of-charge repair or replacement of defective parts only. Parts requiring repair or replacement as a result of normal wear and tear are not covered by this warranty. Additional claims are excluded, unless mandatory national regulations prohibit such exclusion. In particular, Hilti is not obligated for direct, indirect, incidental or consequential damages, losses or expenses in connection with, or by reason of, the use of, or inability to use the product for any purpose. [. . . ]