User manual HILTI PR15

[. . . ] PR 15 Mode d'emploi 2-43 Operating instructions 44-85 Manual de Instrucciones 86-127 PR 15 operating instructions Symbols used The symbols used in these operating instructions have the following meanings: WARNING Usage risk or improper use which can cause severe personal injury or a fatal accident. Usage information which helps the user to employ the instrument efficiently and in a technically correct manner. Besides the instructions for use, these operating instructions also contain important safety notes (see «Safety instructions» section) Please read through these operating instructions carefully before using the tool. . 59 Applications for which the tool is designed . . 60 Electromagnetic compatibility (EMC) . . 66 Operation with the beam catcher (1-30 m) . [. . . ] 4 Manual incline mode can be set using the Speed button . This mode then permits operation in a plane inclined in X- and Y-directions. 5 After finishing the work, switch off the PR 15 using the ON/OFF button . Initial operation and usage Inclined plane mode 1 Depending on the application, mount the PR 15 rotating laser, e. g. 2 Switch on using the ON/OFF button Operation LED lights up green. In this operating mode, the Y direction is levelled automatically and the automatic cut-out is ready. 5 Press Incline button and set Y incline using servo button . 6 Press Incline button and adjust X incline using servo button if necessary. 7 Using the Speed button , select the desired operating mode and carry out the work. 8 After finishing the work, switch off the PR 15 using the ON/OFF button . If the work is interrupted If the Incline button is pressed within 3 seconds after switching on again, the inclined setting is preserved. Otherwise, the tool levels itself automatically. Initial operation and usage Operation in conjunction with a beam catcher (1-30 m) PA 330 / PA 340 1 Set mode to 80 rpm using Speed button . 2 Hold the beam catcher (PA 330 / 340) within the arc of the rotating laser beam. The laser beam follows the hand-held beam catcher, and oscillates within the range of ± 200 to 500 mm at the beam catcher. This causes the laser beam to appear much brighter. Initial operation and usage Operation in conjunction with a manual detector (1-100 m) PA 350 1 Set mode to 300 rpm using Speed button . 2 Hold manual detector (PA350) in the rotating laser beam. The laser beam is indicated optically and acoustically. 3 Carry out marking work. For distances of up to 100 m, or in unfavourable lighting conditions: use the manual detector (PA 350) 68 4. Checks The tool must be checked at regular intervals in order to ensure that it is operating in accordance with the specifications. Checking horizontal rotation Checking the horizontal alignment of the PR 15 1 Set up the tripod at the mid point between wall A and wall B. The distance between A and B should be approx. Note the position of the tool: 3 4 5 6 The tool must lie flat on the tripod plate. [. . . ] The position of the laser beam is indicated optically and acoustically. Measuring rod The measuring rod can be pulled out telescopically, and is equipped with attachment points for the beam catcher and the manual detector. The rod is marked with a measuring scale. Sighting glasses For better visibility of the laser target point. 79 Continued 5. Accessories, continued Tripods Various tripods are available for setting up the PR 15 at the job site. Wall mounting bracket The wall mounting bracket makes it easy to mount the PR 15 on a wall. 80 6. FCC statement (applicable in U. S. ) 6. [. . . ]