User manual HILTI SBP12

[. . . ] SB 12, SBC 12 H, SBP 12 Bedienungsanleitung Operating instructions Safety precautions Caution: The following fundamental safety precautions must always be observed when using electric tools/machines as protection against and electric shock, the risk of injury and fire hazards. Please read and take note of these precautions before you use the tool/machine. Keep these safety precautions in a safe place! 1 Keep your place of work clean and tidy. Disorder where you are working creates a potential risk of accidents. (Please read and keep these instructions) ed, e. g. [. . . ] The screwgun thus requires no maintenance. If used heavily over a long period of time, it is recommended that the screwgun is returned to Hilti for inspection. This can extend the life of the screwgun and avoid unnecessary repair costs. The air intake/exit slots should be kept clean. If an excessive amount of dust collects, clean the screwgun by blowing out dust with a jet of compessed air. Electric tools must comply with the applicable safety regulations. Servicing may only be carried out by a recognised electrical specialist. Optimum safety can be ensured by using only original Hilti spare parts. This warranty provides the free-of-charge repair or replacement of defective parts only. Parts requiring repair or replacement as a result of normal wear and tear are not covered by this warranty. Additional claims are excluded, unless stringent national rules prohibit such exclusion. In particular, Hilti is not obligated for direct, indirect, incidental or consequential damages, losses or expenses in connection with, or by reason of, the use of, or inability to use the tool for any purpose. Implied war- ranties of merchantability or fitness for a particular purpose are specifically excluded. For repair or replacement, send the tool and/or related parts immediately upon discovery of the defect to the address of the local Hilti marketing organization provided. Battery charged - red LED blinks (short intervals) Screwgun - See SB 12 operating instructions. Battery - See SBP 12 operating instructions. tinuously when the SBP12 battery is being charged. Red LED charging indicator blinks (short intervals) The LED charging indicator blinks at short intervals when the battery has been charged. A trickle charging current flows to the battery during this phase of the charging cycle. The battery may be left in the charger for long periods (max. Battery compartment The SBP12 battery clicks into position in the battery compartment ensuring that correct contact is made. Safety Important The enclosed list of safety precautions must be observed! Do not use this product in any way other than as directed by these operating instructions. The mains supply voltage must correspond to the information printed on the rating plate. 230-volt units can also be connected to 220 and 240-volt mains supplies. [. . . ] Servicing may only be carried out by a recognised electrical specialist. Optimum safety can be ensured by using only original Hilti spare parts. Warranty Hilti warrants that the tool supplied is free of defects in material and workmanship. This warranty is valid so long as the tool is operated and handled correctly, cleaned and serviced properly and in accordance with the Hilti Operating Instructions, all warranty claims are made within 12 months from the date of the sale (invoice date), and the technical system is maintained. This means that only original Hilti consumables, components and spare parts may be used in the tool. [. . . ]