User manual HILTI SD45

[. . . ] Never use the cord to carry the tools or pull the plug frcm an outlet. Keep cord away from heat, oil, sharp edges or moving parts. Damaged cords increase the risk of electric shock. 3. 6 When operating a power tool outside, use an outdoor extension cord marked uW-Au or uWu. [. . . ] lf the plug does not fit fully in the outlet, rcverse the plug. lf it still does not fit, contact a qualified electrician to install a polarized outlet. grounded power cord and grounded power supply system. Double insulation E eliminates the need for the three-wire 4. 4 Remove adjusting keys or switches before tuming the tool on. A wrench or a key that is left attached to a rotating part of the tool may result in personal injury. Keep properfooting and balance at all times. Proper footing and balance enables better control of the tool in unexpected situations. Dust mask, non-skid safety shoes, hard hat or hearing protection must be used for appropriate conditions. 5. Follow instructions in the Maintenance section of this manual. Use of unauthorized parts or failure to follow Maintenance Instructions mav create a risk of electric shock or injury Applicable only to Class 3. 3 Avoid body contact ll tools. with grounded surfaces such as pipes, radiators, ranges and rcfrigerators. There is 5. 1 Use clamps or other practical means to secure and suppod the workpiece to a stable platform. Holding the workpiece by hand or against your body is unstable and may lead to loss of control. Additional Specific Safety Rules: 101 Hold tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a parts of the tool "live" "live" wire will make exoosed metal and shock the operator . Hilti SD 45 Drywall Electric Screwdriver 1+zs5es615) Technical data Nominal inout oower: 550 W 120 V cunent: Mains frequencv: No-load speed: Chuck: Tool weiqht: Max. torque: Speed control: Reversing switch: Nominal input Double insulation 5. 5 A 5G0 Hz 0-4300 r. p. m. (t 10%) '/0" hexagon socket 3. 1 lbs. (1. 4 kg) > 7. 5 Nm (4. 1 ft-lbs) Electronic switch Pushtype with lock to prevent switching ounnq operaton Double insulation construction 'I . 2. Chuck 7. On/off switch with electronic variable speed control Reversing switch Lockbutton for sustained operation Depth gauge adjustment Plug Connection This Product is Listed bv Belt hook Underwriters Laborat6ries lnc, and Bears the Mark: Always remove the plug from the nameplate. Don, t connect to a third conductor work on the tool, e. g. , servicing, malntenance, etc. Don't use this product in any other for grounding / earthing. This tool is way than described in the operatdouble insulated Only plug into the main supply when ing instructions the tool is switched off. Check the plug and supply cord for lmportant: lmmediately switch off damage before plugging into a main . [. . . ] Box 21 148 Tulsa, Oklahoma74146 Telephone (918) 252-6000 Switching off sustained operdaon: Press the on/ofi sadtch briefly and the lockbutton will automaticallv be released. screw Gleanin06ewicing/lflaintenance The tool was filled with sufficient grease at the factorv. lt thus needs no additional lubricatiori. lf used heavily over a long period, it's inspection by Hilti is recommended. This will extend the tools' life expectancy and unnecessary repair costs will be avoided. Dirt and dust must not be allowed to build up in cooling air openings. [. . . ]