User manual HILTI SF120-A

[. . . ] battery and chuck: Dimensions (l=h=w): Speed (no load): 12 Volt 2 kg 261=172=61 mm 1st speed: 0­320 r. p. m. Chuck / Quick-release chuck capacity: 1. 5­13 mm Torque: max. 21 Nm (set at drilling symbol) Torque adjustment: 1­12 Nm (at 20 settings) Vibration: less than 2. 5 m/sec2 Noise level (power): less than 70 dB(A) Speed control: electronic via on-off switch Reversing switch: electronic with switching lock when running Spindle lock: when the screwdriver is switched off Motor brake: activated by the control switch Dust-tight enclosure and permanent lubrication (maintenance free) Battery Voltage: Capacity: Weight: Temperature monitoring: Type of cell: No. of cells: Right of technical modifications reserved SBP12 12 Volt 12 Volt=2, 0 Ah = 24 Wh 0. 69 kg yes nickel-cadmium Sub C design 10 SFB125 12 Volt 12 Volt=3, 0 Ah = 36 Wh 0. 73 kg yes nickel-metal hydrid Sub C design 10 Applications Type of screw / application Size Speed Wood screw / chipboard screw in spruce / chipboard Machine screw Screw in plastic anchor Screw Plastic anchor Type of drill / application up to 5 mm dia. [. . . ] Use only the recommended original Hilti accessories and auxiliary equipment. Use the tool only for the purposes for which it is intended (see page 8). Always ensure that you have a safe stance. The drill bit may become stuck unexpectedly. Switch the tool off if you are distracted from your work. Take care to avoid concealed cables and pipes. Concealed electric cables or gas and water pipes pre- 9 Before use The SF120-A may be used only with the SBP12 or SFB125 battery. Before it is used for the first time, it is important that a new battery is charged for 24 hours in normal charging mode or up to 12 hours using the conditioning charging mode, thus permitting "forming" of the battery cells to take place. Battery performance drops at low temperatures. Store the battery at room temperature when not in use. Do not store a battery where it may be subjected to high temperatures, e. g. exposed to the sun, at a window, behind a car windscreen or on a radiator. Do not work with the battery until it is run down. The cells can be damaged if the battery is completely discharged. Speed selection Two-speed switch The speed can be selected using the mechanical twospeed switch, i. e. Only change speed when the screwdriver is not running. Torque selection Torque clutch setting ring The release torque (1­12 Nm) is obtained by turning the setting ring to the desired torque level (setting 1­20). At the drilling symbol ( ), the torque clutch is blocked and the screwdriver gives its max. torque of about 21 Nm (stalling torque) at this setting. Reversing switch The reversing switch is used to reverse the direction of rotation of the chuck. A locking device prevents operation of the switch while the motor is running. The control switch is deactivated when the reversing switch is in the central position. Speed control Switch with electronic speed control The speed can be controlled infinitely from zero to maximum by slowly depressing the switch. Operation Insert tool insertion and removal Use the safety catch as protection against unintentional switching on during transport. [. . . ] Parts requiring repair or replacement as a result of normal wear and tear are not covered by this warranty. Additional claims are excluded, unless stringent national rules prohibit such exclusion. In particular, Hilti is not obligated for direct, indirect, incidental or consequential damages, losses or expenses in connection with, or by reason of, the use of, or inability to use the tool for any purpose. Implied warranties of merchantability or fitness for a particular purpose are specifically excluded. [. . . ]