User manual HILTI SF180-A

[. . . ] SF180-A en Operating instructions 9­16 375007 *375007* 1 7 4 8 153 2 9 6 2 L STOP R 3 2 1 4 1-13 5 7 9 11 13 5 6 7 SF 180-A hammer drill driver 1. General information It is essential that the operating instructions are read before the tool is operated for the first time. Always keep these operating instructions together with the tool. Ensure that the operating instructions are with the tool when it is given to other persons. 1. 1 Indication of danger -CAUTIONUsed to draw attention to a potentially dangerous situation which could lead to minor personal injury or damage to the equipment or other property. [. . . ] q Ensure that batteries are charged using the correct charger recommended by the manufacturer. Incorrect use may result in a risk of electric shock, overheating or leaking of corrosive liquid from the battery. Before use q The insert tool may become hot during use. You should therefore wear protective gloves when changing insert tools. It is essential that the safety precautions printed in these operating instructions are read and observed. A new battery must be charged correctly for the first time before use: ­ charged normally for 24 hours with the SFC 7/8 H charger, or ­ charged for 12 hours using the conditioning function of the SFC 7/18 or TCU 7/36 charger This will ensure that the cells form correctly. Incorrect initial charging may have a permanent, negative effect on battery capacity. -NOTE­ The tool may be used only with SFB 180 or SFB 185 batteries. ­ Battery performance drops at low temperatures. ­ Batteries should be stored at room temperature. ­ Never store batteries where they are exposed to the heat of the sun, on a radiator, behind a motor vehicle windscreen or at a window. ­ Never use the battery until the cells become fully discharged. Change to the second battery as soon as a drop in performance is noticed and recharge the battery immediately so that it is ready for re-use. Open the side handle clamping band by turning the handle. q A caustic liquid may leak from defective batteries. In the event of contact with the skin, wash the area affected with soap and plenty of water. Should the liquid come into contact with the eyes, flush 12 2. Slide the side handle clamping band over the chuck and onto the tool. 7. 2 Setting the speed (2-speed gear selector switch) -CAUTIONOperate the gear selector switch only when rotation has stopped. Select position 1 for a speed range of 0­460 r. p. m. or position 2 for a speed range of 0­1600 r. p. m. 7. 3 Screwdriving Set the desired direction of rotation by way of the forward / reverse switch. 7. 3. 1 Torque setting Set the torque by turning the torque clutch setting ring to the desired torque setting (1­13). The battery cannot be charged through the belt adaptor. [. . . ] Parts requiring repair or replacement as a result of normal wear and tear are not covered by this warranty. Additional claims are excluded, unless stringent national rules prohibit such exclusion. In particular, Hilti is not obligated for direct, indirect, incidental or 16 consequential damages, losses or expenses in connection with, or by reason of, the use of, or inability to use the tool for any purpose. Implied warranties of merchantability or fitness for a particular purpose are specifically excluded. [. . . ]