User manual HILTI SID121-A

[. . . ] SID 121-A / SIW121-A / SID 144-A / SIW144-A Bedienungsanleitung Operating instructions Mode d'emploi Manual de instrucciones Istruzioni d'uso Gebruiksaanwijzing Brugsanvisning Bruksanvisning Bruksanvisning Käyttöohje Manual de instruções Lietoßanas pamåcîba Instrukcija Kasutusjuhend Kulllanma Talimat> de en fr es it nl da no sv fi pt el lv lt et tr 1 2 1 2 SID121-A 4 5 3 9 8 6 7 2 Click 3 2 1 1 1 2 4 5 STOP 6 1 2 7 14. 4 Volt Li-Ion 2. 4 Ah 14. 4 Volt Li-Ion 2. 4 Ah SID 121A / SIW 121A / SID 144A / SIW 144A tangential impact screwdriver It is essential that the operating instructions are read before the power tool is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are with the power tool when it is given to other persons. Contents 1. Manufacturer's warranty - tools 12. [. . . ] Change to the second battery as soon as a drop in performance is noticed. Recharge the battery immediately so that it is ready for reuse. Never store the battery where it is exposed to direct sunlight or sources of heat, e. g. on heaters / radiators or behind a motor vehicle windscreen. Batteries that have reached the end of their life must be disposed of safely and correctly to avoid environmental pollution. Use the Hilti battery only with the approved Hilti chargers listed in the "Insert tools, accessories" section. Ensure that the outer surfaces of the battery are clean and dry before inserting it in the corresponding charger. Read the operating instructions for the charger for further information about the charging procedure. 6. 1. 1 Charging a new battery for the first time 6. 1. 2 Recharging NiCd and NiMH batteries NiCd and NiMH batteries should be allowed to reach full charge each time they are charged. 6. 1. 3 Recharging Li-ion batteries Li-ion batteries are ready for use at any time, even when only partly charged. Charging progress is indicated by the LEDs (please refer to the section "Reading the charge status LED display on Liion batteries"). 6. 1. 4 Fitting the battery to the power tool CAUTION Before fitting the battery, check that the tool is switched off and that the transport lock is engaged (forward/reverse switch in the middle position). Use only the Hilti batteries approved for use with this power tool. Push the battery into the power tool from below until it is heard to engage with a click. CAUTION A falling battery may present a risk of injury to yourself or others. Check that the battery is seated securely in the power tool. 6. 1. 5 Removing the battery from the power tool 2 1. Pull the battery downwards out of the power tool. en A new battery must be charged correctly for the first time before use. This will ensure that the cells form correctly. Incorrect initial charging may have a permanent, negative effect on battery capacity. Please refer to the applicable battery charger's operating instructions for information about initial charging. 7. Operation 7. 1 Changing insert tools CAUTION Wear protective gloves when changing drill bits as the drill bit may get hot during use. [. . . ] Careless disposal may permit unauthorized and improper use of the equipment. This may result in serious personal injury, injury to third parties and pollution of the environment. CAUTION Dispose of defective batteries without delay. Do not attempt to open or dismantle batteries and do not dispose of them by incineration. [. . . ]