User manual HILTI SR16

[. . . ] The illustrations can be found on the fold-out cover pages. Keep these pages open while studying the operating instructions. In these operating instructions, the designation "the power tool" always refers to the TE 1000-AVR and / or SR16 breaker. Components, operating controls and indicators 1 @ Grip ; On / off switch = Supply cord % Theft protection indicator (option) & Service indicator ( Power level indicator (TE 1000AVR) ) Power level selector switch (only TE 1000AVR) + Side handle § Knob / Chuck and chisel position adjustment : Ventilation slots en 1. [. . . ] using a metal detector) to ensure that no concealed electric cables or gas and water pipes are present. External metal parts of the power tool may become live, for example, when an electric cable is damaged accidentally. This presents a serious risk of electric shock. b) Concealed electric cables or gas and water pipes present a serious hazard if damaged while you are working. Accordingly, check the area in which you are working beforehand (e. g. External metal parts of the power tool or machine may become live, for example, when an electric cable is damaged accidentally. Check the power tool's supply cord at regular intervals and have it replaced by a qualified specialist if found to be damaged. If the power tool's supply cord is damaged it must be replaced with a specially-prepared supply cord available from Hilti Customer Service. Check extension cords at regular intervals and replace them if found to be damaged. Do not touch the supply cord or extension cord if it is damaged while working. Disconnect the supply cord plug from the power outlet. Disconnect the supply cord plug from the power outlet. Release the side handle clamping band by turning the knob. 7. Operation 7. 1. 1 Fitting the chisel or other tool 3 NOTE The chisel can be adjusted to 6 different positions (in 60° increments). This ensures that flat chisels and shaped chisels can always be set to the optimum working position. Disconnect the supply cord plug from the power outlet. Check that the connection end of the chisel is clean and lightly greased. Clean it and grease it if necessary. DANGER Always hold the power tool securely with both hands on the grips provided. Keep the grips dry, clean and free from oil and grease. 7. 1 Preparing for use CAUTION Wear protective gloves when changing insert tools as the insert tools get hot through use and they may have sharp edges. 9 en 3. Check that the sealing lip of the dust shield is clean and in good condition. Clean the dust shield if necessary or replace it if the sealing lip is found to be damaged (please refer to the "Care and maintenance" section). [. . . ] Connect the power tool to a different power source. Pull the chuck back as far as it will go and remove the insert tool. No hammering action. The power tool is too cold. en The power tool doesn't start and the LED lights red. The power tool doesn't start and the LED blinks red. The power tool cuts out while running and the LED lights red. [. . . ]