User manual HILTI ST2500

[. . . ] Hilti Corporation FL-9494 Schaan Tel. : +423 / 234 2111 Fax: +423 / 234 29 65 www. hilti. com ST2500 / SD 2500 Bedienungsanleitung Operating instructions Mode d'emploi de en fr Hilti = registered trademark of Hilti Corp. , Schaan W 2823 0803 25-Pos. 1 1 Printed in Liechtenstein © 2003 Right of technical and programme changes reserved S. & O. 378505 378505/A *378505* 1 1 2 2 8 4 7 6 3 5 4 5 1 4 9 I. II. III. 4 5 6 7 8 9 10 11 6 8 4 7 6 Click 7 5 ST 2500 / SD 2500 electric screwdriver It is essential that the operating instructions are read before the tool is operated for the first time. Always keep these operating instructions together with the tool. [. . . ] Avoid body contact with earthed / grounded objects, e. g. pipes, radiators, cookers and fridges. 12 Check the condition of the supply cord at regular intervals and, if found to be damaged, have it replaced by a trained electrical specialist. Check the condition of extension cords at regular intervals and replace them if found to be damaged. Do not operate the tool if it is found to be damaged, if it is not complete or if its controls cannot be operated faultlessly. Do not touch the supply cord in the event of it suffering damage while working. Disconnect the supply cord plug from the socket. Damaged switches must be replaced at a Hilti service center. Do not use the tool if it cannot be switched off and on properly. The tool may be repaired by trained electrical specialists only (Hilti service) using original Hilti spare parts. Failure to observe this point may present considerable risk to the user. Do not use the supply cord for purposes for which it is not intended. Never carry the tool by the supply cord. Do not pull the plug out of the socket by pulling the supply cord. Do not expose the supply cord to heat, oil or sharp edges. When working outdoors, use only extension cords approved and correspondingly marked as suitable for outdoor use. In the event of a power cut: Switch off and unplug the tool. Avoid using extension cords with multiple sockets for simultaneous use of several electric tools or appliances. Never operate the tool when it is dirty or wet. Dust or dampness on the surface of the tool make it difficult to hold and, under unfavorable conditions, may lead to electric shocks. 5. 4 Requirements to be met by users The tool is intended for professional use. The tool may be operated, serviced and repaired only by authorized, trained personnel. The depth gauge can be adjusted to ensure correct compression of the sealing washer under the head of the screw. To decrease compression of sealing washer 1. To increase compression of sealing washer 1. [. . . ] Do not operate the tool if parts are damaged or when the controls do not function faultlessly. If necessary, your electric tool should be repaired at a Hilti repair center. Repairs to the electrical section of the tool may be carried out only by trained electrical specialists 8. 4 Checks after care and maintenance Check that the tool functions correctly (drive and remove a screw) after carrying out care and maintenance. en 9. Disposal Most of the materials from which Hilti electric tools are manufactured can be recycled. [. . . ]