User manual HILTI TE 1000-AVR

[. . . ] TE 1000-AVR / TE 1500-AVR Operating instructions Mode d'emploi Manual de instrucciones Manual de instruções en fr es pt 1 This Product is Certified Ce produit est certifié Este producto esta certificado Este produto está certificado C US 2 3 4 5 6 7 8 9 10 11 ORIGINAL OPERATING INSTRUCTIONS TE 1000AVR / TE 1500AVR Breaker It is essential that the operating instructions are read before the power tool is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are with the power tool when it is given to other persons. Contents 1. Manufacturer's warranty - tools Page 1 2 4 5 6 9 9 11 12 13 14 1 These numbers refer to the corresponding illustrations. [. . . ] Dirty or dusty power tools which have been used frequently for work on conductive materials should be checked at regular intervals at a Hilti Service Center. Under unfavorable circumstances, dampness or dust adhering to the surface of the power tool, especially dust from conductive materials, may present a risk of electric shock. Hold power tool by insulated gripping surfaces when performing an operation where the fastener may contact hidden wiring or its own cord. Fasteners contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. When working outdoors with an electric tool check to ensure that the tool is connected to the electric supply by way of a ground fault circuit interrupter (GFCI) with a rating of max. Use of a ground fault circuit interrupter reduces the risk of electric shock. Use of a ground fault circuit interrupter (GFCI) with a maximum tripping current of 30 mA is recommended. Switch the power tool off and unplug the supply cord in the event of a power failure or interruption in the electric supply. This will prevent accidental restarting when the electric power returns. 8 5. 2. 4 Work area a) Ensure that the workplace is well ventilated. Exposure to dust at a poorly ventilated workplace may result in damage to the health. Objects which could cause injury should be removed from the working area. Untidiness at the workplace can lead to accidents. c) If the work involves breaking right through, take the appropriate safety measures at the opposite side. Parts breaking away could fall out and / or fall down and injure other persons. d) Approval must be obtained from the site engineer or architect prior to beginning the work. Work on buildings and other structures may influence the statics of the structure, especially when steel reinforcing bars or load-bearing components are cut through. en 6. Relax the tension on the side handle clamping band and slide it over the chuck and onto the cylindrical section at the front end of the power tool. Pivot the side handle into the desired position. Secure the side handle by tightening the knob. 6. 2 Unlocking the power tool (theft protection system) See section "Operation / TPS Theft Protection System (optional)". 6. 3 Use of extension cords and generators or transformers See section "Description / use of extension cords". 6. 1 Fitting and adjusting the side handle 2 1. Disconnect the supply cord plug from the power outlet. [. . . ] The power tool doesn't start and the indicator lamp blinks yellow. The power tool doesn't achieve full power. A fault has occurred in the power tool. The voltage provided by the electric supply is too high. The overheating prevention cut-out has been activated. [. . . ]