User manual HILTI TE 106

[. . . ] TE 106 Bedienungsanleitung Operating instructions Mode d'emploi Istruzioni d'uso Manual de instrucciones de en fr it es 1 1 2 4 5 TE 1 06 3 6 06 TE 1 2 3 3 1 4 1 5 2 2 1 3 4 5 1 3 2 1 2 3 4 6 7 1 2 4 3 8 9 2 1 1 3 3 2 10 1 2 4 TE 106 breaker It is essential that the operating instructions are read before the power tool is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are with the power tool when it is given to other persons. Contents 1. Manufacturer's warranty - tools 12. [. . . ] Use clamps or a vice to secure the workpiece. The workpiece is thus held more securely than by hand and both hands remain free to operate the power tool. b) Check that the insert tools used are compatible with the chuck system and that they are secured in the chuck correctly. c) Switch the power tool off and unplug the supply cord in the event of a power failure or interruption in the electric supply. Release the switch lockbutton (if applicable). This will prevent accidental restarting when the electric power returns. 5. 2. 3 Electrical safety b) Check the power tool's supply cord at regular intervals and have it replaced by a qualified specialist if found to be damaged. Check extension cords at regular intervals and replace them if found to be damaged. Do not touch the supply cord or extension cord if it is damaged while working. Disconnect the supply cord plug from the power outlet. Damaged supply cords or extension cords present a risk of electric shock. c) Dirty or dusty power tools which have been used frequently for work on conductive materials should be checked at regular intervals at a Hilti Service Center. 7. 2 Operation DANGER Always hold the power tool securely with both hands on the grips provided. Keep the grips dry, clean and free from oil and grease. CAUTION Use clamps or a vice to hold the workpiece securely. 7. 1 Preparation 7. 1. 1 Fitting the insert tool 2 CAUTION Wear protective gloves when changing insert tools as the insert tools get hot through use and they may have sharp edges. Disconnect the supply cord plug from the power outlet. Check that the connection end of the insert tool is clean and lightly greased. Push the insert tool into the chuck and rotate it while applying slight pressure until it engages in the guide grooves. Push the insert tool further into the chuck until it is heard to engage. Check that the insert tool has engaged correctly by pulling on it. 7. 1. 2 Removing the insert tool 3 CAUTION Wear protective gloves when changing insert tools as the insert tools get hot through use and they may have sharp edges. [. . . ] Pull the chuck back as far as it will go and remove the insert tool. en Other electrical fault. The carbon brushes are worn. No hammering action. The power tool doesn't achieve full power. The power tool is too cold. The extension cord's conductor cross section is inadequate. The control switch is not pressed fully. The chisel can't be released from the chuck. The chuck is not pulled back fully. 10. [. . . ]